FIELD REPLACEABLE UNIT DOCUMENTATION
TM
Satellite
1900 Series
15” DISPLAY MASK REMOVAL
Latch
Display mask
LCD
LCD/FL harness cover
Mask seals
1.Slide the LCD/FL harness cover to the left and lift it out.
2.Remove two mask seals at the bottom corners of the display assembly using a pair of
2.Remove two M2.5x7 flat head black screws securing the display mask.
3.There are 23 latches securing the display mask. Carefully insert your fingers between the mask and the LCD panel and pry open the latches starting from the bottom six latches, to the five latches on the right and left sides, ending with the six top latches.
FL INVERTER AND 15” LCD REMOVAL
LCD module
| M2x3 |
M2x3 | black |
screws | |
black |
|
screws |
|
FL cable
LCD/FL cable | M2x5 silver screw | FL inverter board |
1.Remove two M2x5 silver screw securing the FL inverter board.
2.Carefully lift up the FL inverter board and disconnect the LCD/FL cable from CN1 and the FL cable from CN2.
3.Remove four M2X3 black screws securing the LCD module.
5.Carefully rotate out the top of the LCD module enough to access the display cable
6.Peel off the tape securing the LCD/FL cable and disconnect the cable.
6.Remove eight M2x3 black screws securing the left and right LCD brackets and separate the brackets.
TOSHIBA
Tough Enough for Today’s World