Basics | Resetting the Logic Board - 18 | |
| 5 Verify the power supply cable is disconnected from the |
|
| logic board and then press the Power On button. (See | |
| "Logic Board Diagram" later in this chapter to locate the | |
| Power On button.) | |
| 6 Wait at least 10 minutes before replacing the battery. | |
| Make sure the battery is installed in the correct +/- | |
| direction. | |
| 7 Reassemble the computer and test the unit. | |
| Note: This procedure resets the computer’s PRAM. Be sure | |
| to check the computer’s time/date and other system | |
| parameter settings afterwards. | |
| Note: If this procedure resolves the problem, claim an | |
| adjustment on an SRO. If not, replace the defective | |
| component and DO NOT claim the adjustment procedure. | |