Troubleshooting | Symptom Charts/Error Chords - 4 | |
|
|
|
Error Chords
1Disconnect SCSI data cable from hard drive and reboot system. If startup sequence is normal, initialize hard drive using Drive Setup and then run Drive Setup Updater utility program. Test unit again with SCSI data cable connected. If error chord still sounds, replace hard drive.
2Disconnect floppy drive cable from floppy drive and reboot system. If startup sequence is normal, replace floppy drive.
3Reseat processor card.
4Replace processor card.
5Replace logic board. Retain customer's DIMMs. Note: When you replace the logic board, be sure the LED cable is not interfering with the power actuator.