CMOS
Message Displayed | Description |
|
|
CMOS Date/Time Not | The CMOS Date and/or Time are invalid. This error can be resolved by readjusting |
Set | the system time in AMIBIOS Setup. |
|
|
CMOS Battery Low | CMOS Battery is low. This message usually indicates that the CMOS battery needs |
| to be replaced. It could also appear when the user intentionally discharges the |
| CMOS battery. |
|
|
CMOS Settings | CMOS settings are invalid. This error can be resolved by using AMIBIOS Setup. |
Wrong |
|
|
|
CMOS Checksum | CMOS contents failed the Checksum check. Indicates that the CMOS data has |
Bad | been changed by a program other than the BIOS or that the CMOS is not retaining |
| its data due to malfunction. This error can typically be resolved by using AMIBIOS |
| Setup. |
|
|
Miscellaneous
Message Displayed | Description |
|
|
KBC BAT Test failed | Keyboard controller BAT test failed. This may indicate a problem with keyboard |
| controller initialization. |
|
|
Keyboard Error | Keyboard is not present or the hardware is not responding when the keyboard |
| controller is initialized. |
|
|
PS2 Keyboard not | PS2 Keyboard support is enabled in the BIOS setup but the device is not detected. |
found |
|
|
|
PS2 Mouse not found | PS2 Mouse support is enabled in the BIOS setup but the device is not detected. |
|
|
Keyboard/Interface | Keyboard Controller failure. This may indicate a problem with system hardware. |
Error |
|
|
|
Unlock Keyboard | PS2 keyboard is locked. User needs to unlock the keyboard to continue the BIOS |
| POST. |
|
|
System Halted | The system has been halted. A reset or power cycle is required to reboot the |
| machine. This message appears after a fatal error has been detected. |
|
|
<INS> Pressed | Indicates that <INS> key is pressed during the BIOS POST. The POST will load and |
| use default CMOS settings. |
|
|
Password check | The password entered does not match the password set in the setup. This condition |
failed | may occur for both Supervisor and User password verification. |
|
|
Unknown BIOS error. | This message is displayed when ADM module is not present in the AMIBIOS8 |
Error code = 004Ah | ROM. |
|
|
Unknown BIOS error. | This message is displayed when language module is not present in the AMIBIOS8 |
Error code = 004Bh | ROM. |
|
|
Floppy Controller | Error in initializing legacy Floppy Controller. |
Failure |
|
|
|
64 | Chapter 4 |