Acer M5810 manual Storage Device

Page 54

 

Message

Description

 

Displayed

 

 

 

 

 

 

B: Drive Error

The BIOS attempted to configure the B: drive during POST, but was unable to properly

 

 

configure the device. This may be due to a bad cable or faulty diskette drive.

 

 

 

 

Insert BOOT

The BIOS attempted to boot from the A: drive, but could not find a proper boot diskette.

 

diskette in A:

 

 

 

 

 

Reboot and

BIOS could not find a bootable device in the system and/or removable media drive does

 

Select proper

not contain media.

 

Boot device or

 

 

Insert Boot

 

 

Media in

 

 

selected Boot

 

 

device

 

 

 

 

 

NO ROM

This message occurs on some systems when no bootable device can be detected.

 

BASIC

 

 

 

 

Storage Device

 

 

 

 

Message

Description

 

Displayed

 

 

 

 

 

 

Primary

The IDE/ATAPI device configured as Primary Master could not be properly initialized by the

 

Master Hard

BIOS. This message is typically displayed when the BIOS is trying to detect and configure

 

Disk Error

IDE/ATAPI devices in POST.

 

 

 

 

Primary Slave

The IDE/ATAPI device configured as Primary Slave could not be properly initialized by the

 

Hard Disk

BIOS. This message is typically displayed when the BIOS is trying to detect and configure

 

Error

IDE/ATAPI devices in POST.

 

 

 

 

Secondary

The IDE/ATAPI device configured as Secondary Master could not be properly initialized by

 

Master Hard

the BIOS. This message is typically displayed when the BIOS is trying to detect and

 

Disk Error

configure IDE/ATAPI devices in POST.

 

 

 

 

Secondary

The IDE/ATAPI device configured as Secondary Slave could not be properly initialized by

 

Slave Hard

the BIOS. This message is typically displayed when the BIOS is trying to detect and

 

Disk Error

configure IDE/ATAPI devices in POST.

 

 

 

 

3rd Master

The IDE/ATAPI device configured as Master in the 3rd IDE controller could not be properly

 

Hard Disk

initialized by the BIOS. This message is typically displayed when the BIOS is trying to

 

Error

detect and configure IDE/ATAPI devices in POST.

 

 

 

 

3rd Slave Hard

The IDE/ATAPI device configured as Slave in the 3rd IDE controller could not be properly

 

Disk Error

initialized by the BIOS. This message is typically displayed when the BIOS is trying to

 

 

detect and configure IDE/ATAPI devices in POST.

 

 

 

 

4th Master

The IDE/ATAPI device configured as Master in the 4th IDE controller could not be properly

 

Hard Disk

initialized by the BIOS. This message is typically displayed when the BIOS is trying to

 

Error

detect and configure IDE/ATAPI devices in POST.

 

 

 

 

4th Slave Hard

The IDE/ATAPI device configured as Slave in the 4th IDE controller could not be properly

 

Disk Error

initialized by the BIOS. This message is typically displayed when the BIOS is trying to

 

 

detect and configure IDE/ATAPI devices in POST.

 

 

 

 

5th Master

The IDE/ATAPI device configured as Master in the 5th IDE controller could not be properly

 

Hard Disk

initialized by the BIOS. This message is typically displayed when the BIOS is trying to

 

Error

detect and configure IDE/ATAPI devices in POST.

 

 

 

47

Chapter 4

Image 54
Contents Acer Aspire M5810 Service Guide Revision History Copyright Disclaimer Conventions Service Guide Coverage Table of Contents Features ChapterSerial ATA controller Optical diskGraphics card support AudioSystem Bios Power supplyTotal I/O ports Placement Label DescriptionBlock Diagram Intel ProcessorSystem Components Front PanelComponent Rear Panel Power Management FunctionACPI support function Cmos Setup Utility System UtilitiesEntering Cmos setup Navigating Through the Setup UtilitySetup Utility Menus Parameter DescriptionProduct Information Standard Cmos Features Parameter Description OptionAdvanced Bios Feature EnabledAdvanced Chipset Features AutoIntegrated Peripherals Power Management Setup PC Health Status Frequency/Voltage Control Bios Security Features Setting a supervisor passwordLoad Default Settings Save & Exit Setup Exit Without Saving System Disassembly Disassembly RequirementsPre-disassembly Procedure Removing the Side Panel Removing the Heat Sink Fan Assembly Removing the Processor Removing the VGA Card Removing the Mode Card Removing the TV CardRemoving the Hard Disk Drive Page Removing the Front Bezel Removing the Optical Drive Remove Cables Remove System FAN Removing the Power Supply Removing the Memory Modules Removing the Mainboard System Troubleshooting Power-On Self-Test Post Checkpoint DescriptionBootblock Recovery Code Checkpoints Early CPU Init Start -- Disable Cache ?C Init Local Apic Extended Bios Data Area from base memory DIM Code Checkpoints Post Error Messages List Message Description DisplayedStorage Device Atapi Virus Related Description DisplayedCmos Miscellaneous USB eModule Error Messages Message Displayed DescriptionMain board and Memory Error Symptoms ListError Symptom Action/FRU Processor / Processor Fan Diskette DriveError Symptom Action/FRU Hard Disk DriveCD/DVD-ROM Drive Modem Real-time clockAudio Video and MonitorPower Supply KeyboardOther Problems Undetermined Problems System Board Jumper Setting Jumper SettingSetting Jumper System Board Header SettingFront USB Front Audio HDA Chapter Sata Connector Pin FAN Header Clear Cmos Header Clrsrtc Intr AUX-IN FRU Field Replaceable Unit List Aspire M5810 Exploded Diagram Name Type ’TY Aspire M5810 FRU List Category Description Part NumberHD4870 1GB DDR 5 256BITS Hynix 6 Layer Dual DVI NEW Keyboard Chapter Category Description Part Number Chapter Category Description Part Number Chapter Intel RAID SOP Create Sata RAIDChapter Create Sata RAID Create Sata RAID 0+1 Page Intel RAID SOP Windows for WIN7 Page Picture6 Select Menber Hard Drives Picture7 Page Chapter Page Chapter Page Chapter