Acer M5810 manual Create Sata RAID

Page 85

Step 9:Press "Create Volume" to create RAID0,it will pop the warning message that all data will be lost,"press "Y" to confirm it.

Picture5

Step 10:It will back to create RAID interface,then press "ESC" or select 4 to exit and install OS.

1-2: Create SATA RAID 1

Step 1:Shut down the EUT, unplug the power cable,connect two SATA HDDS to EUT , check the EUT all devices are connect/plug ok.

Step 2:Press "PWR-BTTN" to power on the EUT,Load BIOS default setting . Step 4:During BIOS post, press <Ctrl-I> to enter into Intel RAID setup utility.

Step 5: Select "1" to enter create RAID mode ,if there is no enough avalable space (there was exist a Raid , delete it ).

Step 6:Create RAID 1 Mode,enter the RAID name,such as "MyRaid1",default is"Volume0". Step 7:Select "RAID1(Mirror)" at "RAID Level".

Picture6

Chapter 7

78

Image 85

Contents Acer Aspire M5810 Service Guide Revision History Copyright Disclaimer Conventions Service Guide Coverage Table of Contents Chapter FeaturesGraphics card support Optical diskSerial ATA controller AudioPower supply System BiosTotal I/O ports Label Description PlacementIntel Processor Block DiagramFront Panel System ComponentsComponent Rear Panel Power Management FunctionACPI support function System Utilities Cmos Setup UtilityNavigating Through the Setup Utility Entering Cmos setupParameter Description Setup Utility MenusProduct Information Parameter Description Option Standard Cmos FeaturesEnabled Advanced Bios FeatureAuto Advanced Chipset FeaturesIntegrated Peripherals Power Management Setup PC Health Status Frequency/Voltage Control Setting a supervisor password Bios Security FeaturesLoad Default Settings Save & Exit Setup Exit Without Saving Disassembly Requirements System DisassemblyPre-disassembly Procedure Removing the Side Panel Removing the Heat Sink Fan Assembly Removing the Processor Removing the VGA Card Removing the TV Card Removing the Mode CardRemoving the Hard Disk Drive Page Removing the Front Bezel Removing the Optical Drive Remove Cables Remove System FAN Removing the Power Supply Removing the Memory Modules Removing the Mainboard System Troubleshooting Checkpoint Description Power-On Self-Test PostBootblock Recovery Code Checkpoints Early CPU Init Start -- Disable Cache ?C Init Local Apic Extended Bios Data Area from base memory DIM Code Checkpoints Message Description Displayed Post Error Messages ListStorage Device Atapi Description Displayed Virus RelatedCmos Miscellaneous Message Displayed Description USB eModule Error MessagesError Symptom Action/FRU Processor / Processor Fan Error Symptoms ListMain board and Memory Diskette DriveHard Disk Drive Error Symptom Action/FRUCD/DVD-ROM Drive Audio Real-time clockModem Video and MonitorKeyboard Power SupplyOther Problems Undetermined Problems Setting Jumper Jumper SettingSystem Board Jumper Setting System Board Header SettingFront USB Front Audio HDA Chapter Sata Connector Pin FAN Header Clear Cmos Header Clrsrtc Intr AUX-IN FRU Field Replaceable Unit List Aspire M5810 Exploded Diagram Name Type ’TY Category Description Part Number Aspire M5810 FRU ListHD4870 1GB DDR 5 256BITS Hynix 6 Layer Dual DVI NEW Keyboard Chapter Category Description Part Number Chapter Category Description Part Number Chapter Create Sata RAID Intel RAID SOPChapter Create Sata RAID Create Sata RAID 0+1 Page Intel RAID SOP Windows for WIN7 Page Picture6 Select Menber Hard Drives Picture7 Page Chapter Page Chapter Page Chapter