Recall Defaults
D F 1
RS-232 Parameter - Hardware Handshaking
To prevent scanned information from being lost during transmission, your host device may require an RTS/CTS signal. When the RTS/CTS (Request To Send/Clear To Send) is enabled, the scanner will output an RTS signal and wait for a CTS signal before any data is transmitted. The default setting of RTS/CTS is disabled. If necessary, scan the ENABLE RTS/CTS bar code.
Enable RTS/CTS
H H 1
** Disable RTS/CTS
H H 2
**Character RTS/CTS When this option is chosen, the scanner will
|
|
|
|
|
|
|
|
|
|
|
|
| activate and deactivate its RTS signal on each |
|
|
|
|
|
|
|
|
|
|
|
|
| character that it transmits. |
|
|
| R |
|
|
|
| 5 | 6 |
|
| ||
Message RTS/CTS | When this option is chosen, the scanner will activate | ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| and deactivate its RTS signal on each message that it |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| transmits. This mode should normally be enabled for |
|
|
| R |
|
|
|
| 5 |
| 7 |
|
| Sanyo registers. |
RS-232 Parameter - Software Handshaking
For control of the data transmission process, use ACK/NAK or XON/XOFF instead of or in addition to the RTS/CTS hardware handshaking option.
Enable ACK/NAK
S H 2
** Disable ACK/NAK
When this option is enabled, the scanner will not scan again unless an ACK (ASCII 06H) is received after transmission of a bar code. If an
NAK (ASCII 15H) is received, the scanner will retransmit the bar code.
S H 1
Enable XON/XOFF
S H 4
** Disable XON/XOFF
When this option is enabled, the scanner will stop transmission whenever an XOFF (ASCII 13H) is received. Transmission will resume after an XON (ASCII 11H) is received.
S H 3
11