9
VOLUME Control
Volume levels may be adjusted and stored for each of the four inputs in order to compensate for different audio input levels from the various sources. The volume circuitry is active, allowing the output signal voltage to be set either higher or lower than the original input signal. Press the upper button to increase the volume level or the lower button to decrease the volume level. If either button is pressed and quickly released, the volume level will change up or down by one step out of a total adjustment range of 40 steps. If either button is pressed and held the volume will quickly increase or decrease.
If no volume level has been stored for an input, the factory default level (15 steps below maximum) is automatically recalled each time the input is selected or at power on.
Bass and treble can also be adjusted and stored for inputs 1 - 4 using
HUE Control
This control functions for Inputs 1 - 3 when receiving NTSC input signals (it has no effect on PAL or SECAM input signals). The HUE control has no effect on the passive RGB input. The top button skews the hue phase toward the Red end of the color spectrum and the bottom button adjusts the phase towards the Green end of the spectrum. Pressing either button once quickly adjusts the hue setting by one step out of a total adjusment range of 63 steps. Press and hold either adjustment button for a continuous rapid hue adjustment. The factory default setting is in the middle of the range.
COLOR Control
The unit employs an automatic color level circuit, and the color saturation level can be adjusted over a limited range (±5%). The COLOR control will not reduce the color to zero. The COLOR control has no effect on the passive RGB input. The top button increases the color saturation and the bottom button decreases the color saturation. Pressing either button once quickly adjusts the color setting by one step out of a total adjusment range of 8 steps. Press and hold either adjustment button for a continuous rapid color adjustment. The factory default setting is three steps above the minimum setting.
CONTRAST Control
Along with the GAMMA control, the CONTRAST control is very critical for proper adjustment of the unit. The control labeled CONTRAST actually controls both contrast and sharpness. The unit has been programmed with 32 contrast / sharpness settings. Every time an upper or lower button is pushed the unit will change one "click" to the next setting. Press and hold either adjustment button for a continuous rapid adjustment.
The factory default setting is at the bottom of the range (contrast and sharpness
set for flat gain). The higher contrast settings are located at the top of the
adjustment range. It is recommended that users set the CONTRAST control to 
the extreme top position and move down one step at a time until a pleasing
picture is attained. For most applications, the best image will occur with one 
of the 6 - 8 highest sharpness / contrast settings.
©1994 - INLINE, INC. | IN1222 / IN1422 / IN1510 / IN1710 OPERATIONS MANUAL - REV. 2 12/04/99 |