15
UNIVERSAL POWER SUPPLY
The IN1222 / IN1510 / IN1422 / IN1710 employ a universal (switch mode) power supply which automatically adjusts to accept input voltages worldwide. Input voltage can range between 96V and 260V AC and frequency may range from 50 Hz to 90Hz. The power entry module uses an IEC standard male connector for power connection. U.S. domestic units are shipped with a standard IEC female to Edison male power cable.
Changing Fuses
The power entry module includes a
1.Remove the power cord from the unit.
2.Use a flat blade screwdriver to remove the fuse holder.
3.Replace the blown fuse with the spare fuse.
4.Replace the spare fuse with a new .5A 250V slow blow fuse.
5.Seat the fuse holder back into the power entry module and reattach the power cord.
THE IN1222 / IN1510 / IN1422 / IN1710 CONTAIN NO INTERNAL FUSES,
JUMPERS, DIP SWITCHES OR OTHER USER SERVICABLE PARTS. IF
THE CASE IS OPENED THERE IS ELECTRIC SHOCK HAZARD AND
DAMAGE MAY OCCUR TO THE COMPONENTS. REFER ALL SERVICE TO 
INLINE.
RGB PIN OUT INFORMATION
The following information applies to the
Input 4 - RGB Passive Input
RGB Output
Input 4 and the RGB output both employ a
Pin 1 | Red Signal | Pin 9 | No connection |
Pin 2 | Green Signal | Pin 10 | Ground |
Pin 3 | Blue Signal | Pin 11 | No connection |
Pin 4 | No connection | Pin 12 | No connection |
Pin 5 | Ground | Pin 13 | Horizontal Sync or Composite Sync Signal |
Pin 6 | Red ground | Pin 14 Vertical Sync Signal | |
Pin 7 | Green ground | Pin 15 | No connection |
Pin 8 | Blue ground |
|
|
The output sync format for decoded / doubled images (Inputs 1 - 3) has no effect on the output format of RGB signals sent into Input 4. For instance, if the scan doubler is set to output RGBS, an RGBHV signal applied to Input 4 will still appear at the output as RGBHV, but the decoded / doubled signals will appear at the output as RGBS.
©1994 - INLINE, INC. | IN1222 / IN1422 / IN1510 / IN1710 OPERATIONS MANUAL - REV. 2 12/04/99 |