Postl Postr | AOC IN1222, IN1710, IN1510, IN1422 manual

(Vol./Hue/Color/Cont./Gamma/S-Video/Doubling Mode/Secam)

COMMAND

HUE+

HUE-

HUE,

HUExxx

INTP0

INTP1

INF0 *

MUTE0

MUTE1

POSTL

POSTR

POSTHxx

SAT+

SAT-

SAT,

SATxxx

SAVE

SAVEs

SAVE0

SEC0

SEC1

SVIDEO0

SVIDEO1

SYNC0	**
SYNC1	**
SYNC2	**
SYNC4	**
TRE+
TRE-
TRE,
TRExxx
VOL+
VOL-
VOLxxx
VOL,

DESCRIPTION

Increase HUE phase 1 step

Decrease HUE phase 1 step

Set HUE phase to normal setting default

Set HUE phase to xxx value, range for xxx: 000-255

(IN1222/IN1422 only) Set Doubling Mode to Line Doubling default

(IN1222/IN1422 only) Set Doubling Mode to Frame Mode

Get the model number & firmware version

Disable Audio Mute default

Enable Audio Mute

Horizontal position adjustment - shift left	(Only when doubling is disabled)
Horizontal position adjustment - shift right	(Only when doubling is disabled)

Horizontal position adjustment - set to xx, range of xx: 00-FF (Doubling disabled)

Increase COLOR level 1 step

Decrease COLOR level 1 step

Set COLOR level to normal setting default

Set COLOR level to xxx value, xxx: 000-255

Save current channel’s settings

Save the current channel’s settings to a selected channel s (s = 1, 2, or 3)

Save the global settings (baud rate, command code)

Disable SECAM decoder default

Enable SECAM decoder

Select composite video input for the current channel

Select S-Video input for the current channel default

Select H & V Output Sync, positive polarity

Select H & V Output Sync, negative polarity default

Select Composite Output Sync

Select Sync on RGB

Increase Treble level by 3dB

Decrease Treble level by 3dB

Set Treble level to 0dB default

Set Treble level to xxx value, range for xxx: 240 - 255

Increase volume 8dB

Decrease volume 8dB

Set volume level to xxx value, range for xxx: 192 to 255

Set volume level to normal, default

*This code prompts the unit for feed back and will result in special response codes.

**When the output sync is changed via these RS-232 commands, the new setting is automatically saved as soon as the command is sent (there is no need to send the SAVE or SAVE0 command).

IN1222 / IN1422 / IN1510 / IN1710 OPERATIONS MANUAL - REV. 2 12/04/99