Advantech MIC-3368 manual Connectors, Clear Cmos JP1

Page 15

The jumper settings are schematically depicted in this manual as follows:

You may find a pair of needle-nose pliers useful for setting the jumpers.

If you have any doubts about the best hardware configuration for your application, contact your local distributor or sales representative before you make any changes.

1.4.3 Clear CMOS (JP1)

This jumper is used to erase CMOS data and reset system BIOS information. Follow the procedures below to clear the CMOS.

1.Turn off the system.

2.Close jumper JP2 (2-3) for about 3 seconds.

3.Close jumper JP2 (1-2).

4.Turn on the system. The BIOS is reset to its default setting.

Table 1-2: Clear CMOS

CMOS JP1

Clear

Normal (default)

1.5 Connectors

On-board connectors link to external devices such as hard disk drives, keyboards, or floppy drives, etc. Table 1-3 lists the function of each connector and Figure 1-2 and Figure 1-3 illustrate each connector location. Chapter 2 gives instructions for connecting external devices to your card.

Table 1-3 MIC-3368 connector descriptions

Number Function

CN1 Secondary IDE (CF)

CN2 Primary IDE

CN4 SODIMM Socket

CN5 Ethernet RJ-45 Connector

MIC-3368 Series User Manual -- Page 7

Image 15
Contents MIC-3368 Copyright Notice AcknowledgementsCE Notification Product warranty Packing List Technical Support and Sales AssistanceHttp//support.advantech.com.tw Contents Programming the Watchdog Timer Figures Tables Hardware Configuration Introduction Standard SBC Functions SpecificationsFunctional Block Diagram 1MIC-3368 functional block diagram Jumper Settings JumpersJumper Locations Clear Cmos JP1 Connectors2MIC-3368 jumper and connector locations Safety PrecautionsInstalling Sdram SODIMMs Heat sink installation Installing CPU Heat SinkSoftware support Connecting Peripherals Serial Ports CN1 and CN2 VGA Display Connector CN3PS/2 Keyboard and Mouse Connector CN5 IDE Device CN10Card Installation Ethernet Configuration CN6 and CN7USB Connector CN4 PMC Connector CN4To remove a card To install a cardEthernet Software Configuration Utility and Drivers General InformationFor Microsoft Windows \MIC3368\LAN\DOS\E100B.DOS Drivers for Lantastic Installation for Windows NTFor Unix For Other Operating SystemsPage AGP-SVGA Installation of Svga Driver Bios Award Bios Setup Entering SetupStandard Cmos Setup Bios Features Setup Virus WarningCPU Internal Cache/External Cache Boot Up NumLock Status Quick Power On Self TestBoot Sequence Boot Up Floppy SeekTypematic Rate Char/Sec Chipset Features SetupTypematic Rate Setting Typematic Delay msecPower Management Setup Power ManagementVGA Shared Memory Size 6 PNP/PCI Configuration Setup HDD Power ManagementIntegrated Peripherals IDE HDD Auto Detection Load Setup DefaultsPassword Setting Save & Exit SetupProgramming Watchdog Timer Data Time Interval Programming the Watchdog TimerPin Assignments System Slot J1 Connector System Slot P2 Connector System and Peripheral Slots J3 Connector System Slot J4 Connector System Slot J5 Connector Ethernet RJ-45 Connectors CN5 Eide Connector CN1RJ45-COM1 Serial Ports CN7 VGA Display connector CN6CompactFlash Socket CN9-Optional Fan Module Connectors CN8Interrupt Assignments System I/O Ports14 1st MB Memory Map