Advantech MIC-3368 manual To install a card, To remove a card

Page 23

remove the card easily and safely. Follow the procedure below to install the MIC-3368 into a chassis:

To install a card:

1.Hold the card vertically. Be sure that the card is pointing in the correct direction. The components of the card should be pointing to the right-hand side.

2.Pull out both handles to unlock it.

Caution: Keep your fingers away from the hinge to prevent your fingers from getting pinched.

3.Insert the card into the chassis by sliding the upper and lower edges of the card into the card guides.

4.Push the card into the slot gently by sliding the card along the card guide until the handles meet the rectangular holes of the cross rails. Note: If the card is correctly positioned and has been slid all the way into the chassis, the handle should match the rectangular holes. If not, remove the card from the card guide and repeat step

3again. Do not try to install a card by forcing it into the chassis.

5.Pull the upper handle down and lift the lower handle up to push the card into place.

6.Secure the card by pushing in the red handle to lock it into place.

To remove a card:

1.Unscrew the screws on the front panel.

2.Lift the upper handle up and press the lower handle down to release the card from the backplane.

3.Slide the card out.

Figure 2-1:Installing the card into the chassis

MIC-3368 Series User Manual -- Page 15

Image 23
Contents MIC-3368 CE Notification Copyright NoticeAcknowledgements Product warranty Http//support.advantech.com.tw Packing ListTechnical Support and Sales Assistance Contents Programming the Watchdog Timer Figures Tables Hardware Configuration Introduction Standard SBC Functions SpecificationsFunctional Block Diagram 1MIC-3368 functional block diagram Jumper Locations Jumper SettingsJumpers Clear Cmos JP1 Connectors2MIC-3368 jumper and connector locations Safety PrecautionsInstalling Sdram SODIMMs Heat sink installation Installing CPU Heat SinkSoftware support Connecting Peripherals Serial Ports CN1 and CN2 VGA Display Connector CN3PS/2 Keyboard and Mouse Connector CN5 IDE Device CN10Card Installation Ethernet Configuration CN6 and CN7USB Connector CN4 PMC Connector CN4To remove a card To install a cardEthernet Software Configuration For Microsoft Windows Utility and DriversGeneral Information \MIC3368\LAN\DOS\E100B.DOS Drivers for Lantastic Installation for Windows NTFor Unix For Other Operating SystemsPage AGP-SVGA Installation of Svga Driver Bios Standard Cmos Setup Award Bios SetupEntering Setup CPU Internal Cache/External Cache Bios Features SetupVirus Warning Boot Up NumLock Status Quick Power On Self TestBoot Sequence Boot Up Floppy SeekTypematic Rate Char/Sec Chipset Features SetupTypematic Rate Setting Typematic Delay msecVGA Shared Memory Size Power Management SetupPower Management Integrated Peripherals 6 PNP/PCI Configuration SetupHDD Power Management IDE HDD Auto Detection Load Setup DefaultsPassword Setting Save & Exit SetupProgramming Watchdog Timer Data Time Interval Programming the Watchdog TimerPin Assignments System Slot J1 Connector System Slot P2 Connector System and Peripheral Slots J3 Connector System Slot J4 Connector System Slot J5 Connector Ethernet RJ-45 Connectors CN5 Eide Connector CN1RJ45-COM1 Serial Ports CN7 VGA Display connector CN6CompactFlash Socket CN9-Optional Fan Module Connectors CN8Interrupt Assignments System I/O Ports14 1st MB Memory Map