Alienware M17X R4 owner manual Replacing the Display, Assembly

34	Replacing the Display
	Assembly

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before You Begin" on page 9. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/ regulatory_compliance.

Procedure

1Place the display assembly in position and replace the screws that secure the display assembly to the computer base.

2Route the display cable, camera cable, infrared cable, wirelessHD card cable, and Mini-Card antenna cables through the routing guides on the palm rest assembly.

3Connect the display cable to the connector on the system board.

4Tighten the captive screws that secure the display cable to the system board.

5Connect the camera cable and infrared cable to the respective system board connectors.

Postrequsites

1Connect the wirelessHD card cable to the connector on the wirelessHD card. See "Replacing the WirelessHD Card" on page 54.

2Connect the Mini-Card antenna cables to the Mini-Card. See "Replacing the Mini-Card" on page 51.

3Replace the keyboard. See "Replacing the Keyboard" on page 48.

4Replace the center control cover. See "Replacing the Center Control Cover" on page 44.

5Replace the compartment door. See "Replacing the Compartment Door" on page 15.

6Replace the battery pack. See "Replacing the Battery Pack" on page 13.

7Follow the instructions in "After Working Inside Your Computer" on page 11.

60 Replacing the Display Assembly