Daily Care and Maintenance
Replacing the Battery for the unit clock
When the clock battery has been drained, the time set- up screen is displayed each time the unit’s power is turned on.
Replace the battery as follows and set the current time (see page 26).
1 | Loosen the screw attached to the lower side of |
the Control Panel 1, then remove the battery | |
| holder 2. |
| 2 | 1 |
|
| |
|
| Screw |
| Note |
|
| • Do not loosen any other screws. | |
2 | Remove the old battery and install the new one | |
with the positive (“+”) terminal upward. |
• Always use “CR2032” batteries and be sure that the battery is inserted as indicated on the battery holder.
Old battery
New battery
CR2032 | CR2032 |
| |
PS |
|
3 | Set the battery holder with the battery side |
upward and retighten the screw in step 1. |
Note
•Dispose of expired battery quickly, by covering the terminals in tape and following the disposal regulations in your country/area.
For U.S.A
This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/ perchlorate
For Brazil
Após o uso as pilhas / baterias contidas neste produto poderão ser dispostas em lixo doméstico.
For Netherlands
Bij dit produkt zijn batterijen geleverd. Wanneer deze leeg ziju, moet u ze niet weggooien maar inleveren als KCA.
For Taiwan ( 台灣 )
4 Set the current time. (See page 26.)
30