3M C2167PW manual Connecting the Display, Supported Video Display Modes and Refresh Rates

Page 12

12

3M™ Multi-Touch Display User Guide

Connecting the Display

To setup this display, please refer to the following figures and procedures.

Be sure all equipment is turned off.

Connect the DC adapter to the power connector (DC IN) on the monitor and the other end into an electrical outlet.

Connect the D-SUB cable from the display’s VGA input connector to the D-SUB connector of your host computer and tighten the screws.

Connect the DVI cable from the display’s DVI input to the DVI connector of your host computer and tighten the screws.

Connect the USB cable from the USB port of your display to the USB port of your computer.

Configure the touch screen. Refer to the “Touch Scre en Driver Installation” section.

Once the touch screen is configured, the monitor is ready for use.

Connect the remote control cable to RJ-type port (optional). Don't connect telephone or internet cable to RJ-type port. Adapter rating is 12Vdc 3A minimum, marked with LPS.

Note: To ensure the LCD display works well with your computer, please configure the display mode of your graphics card to make it less than or equal to 1920 x 1020 resolution and make sure the timing of the display mode is compatible with the LCD display.

WARNING

To avoid the risk of electric shock which could cause serious injury or death:

Plug power cord into appropriate grounded power source.

Do not use a power cord that is frayed or otherwise damaged.

Do not use a damaged display or power supply.

Do not use a substitute DC power adapter. Use only the DC adapter provided for the display.

Do not use non-conforming replacement parts..

Supported Video Display Modes and Refresh Rates

Your video card should support one of the display modes specified below. If you select an unsupported video mode, the display may stop working or display unsatisfactory picture quality.

3M Touch Systems, Inc. Proprietary Information – TSD-44310 REV B

Image 12
Contents 3M Multi-Touch Display User Guide 3M Multi-Touch Display User Guide Contents Multi-Touch Display Features IntroductionOverview Important Safety Information Explanation of Signal Word ConsequencesTouch Screen for Multi-Touch Displays Intended Use∙ Do not install or use this product in a hazardous location Important Notes Touch Sensor Care and Cleaning 3M Touch Systems Support ServicesMaintaining Your Touch Display Contact 3M Touch Systems Setting Up Your Multi-Touch Chassis Display Unpacking Your Touch DisplayAttaching the Side Brackets C2167PWTop and bottom brackets Connecting the Display Supported Video Display Modes and Refresh RatesConfiguring the Display Settings Adjusting the Multi-Touch Chassis Video DisplayDisplay Mode User Controls For On Screen DisplayHow to Use the OSD Menus ContentOn-Screen Display Menus Troubleshooting Your Multi-Touch Chassis Display No image appears on screenImage is unstable and flickering Enabling Your Multi-Touch Chassis Display Windows 7 USB CompatibilityAll Other Platforms Installing 3M MicroTouch Software Multi-Touch Application SupportRegulatory Information Regulatory Agency ApprovalsFCC Warning