3M C2167PW manual Important Notes

CAUTION

using any solvents.

∙It is important to avoid using any caustic chemicals on the touch sensor.

To avoid possible environmental contamination which may cause minor or moderate injury:

∙The LCD lamps inside this product contain mercury (Hg). This product may contain other electronic waste that can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal laws. For more information, contact the Electronic Industries Alliance at www.eiae.org. For lamp specific disposal information, check with www.lamprecycle.org. For more information, call 3M Touch Systems at 1-866-407-6666.

∙Dispose of the flat panel display, power adaptor and electronics, according to applicable governmental regulations.

To reduce the risk of muscle strain related to accessibility which may cause minor or moderate injury and/or property damage:

∙Do not install the monitor in a manner or location with awkward accessibility. Extended use may cause muscle, tendon, or fixed posture strains. It is recommended you take periodic breaks from continuous use.

NOTICE

∙You are notified that any change or modification to the equipment not expressly approved by the party responsible for compliance could void your authority to operate such equipment.

∙Do not use longer screws as they could potentially damage electronics inside the display.

Important Notes

∙In extreme temperature and humidity situations, you may observe condensation between the touch screen and the display. To minimize this condition, place the unit where it will be used and allow a 24-hour environmental stabilization period prior to powering on the display. Any noticeable condensation is temporary and will have no long term affect on the operation of the display.

∙When unplugging power supply cord, hold the plug, do not pull by the cord.

∙Do not connect or disconnect this product during an electrical storm.

∙Install the display in a well-ventilated area. Always maintain adequate ventilation to protect the display from overheating and to ensure reliable and continued operation.

∙Do not expose this display to direct sunlight or heat. Passive heat may cause damage to the housing and other parts.

∙An inherent characteristic of the PCT sensor is a fine grid pattern that may be visible under certain lighting conditions.

∙Do not install this display in areas where extreme vibrations may be generated. For example, nearby manufacturing equipment may produce strong vibrations. The vibrations may cause the display to exhibit picture discoloration or poor video quality.

∙The 3M touch controllers mentioned in this document, are USB compatible full speed devices.

3M Touch Systems, Inc. Proprietary Information – TSD-44310 REV B