Wall Mounting Your 522D-SS Dipole/Bipole Speakers
Your
Step 1: Make sure the wall you have selected can support the speakers.
Step 2: Hold the speaker in position to make sure it does not interfere with electrical wiring or plumbing.
Step 3: Use a level as a guide and lightly draw a 18” long pencil line on the wall.
Step 4: Attach the included template to the wall by aligning the line with the level line you have drawn on the wall.
Step 5: Drill a 3/32” pilot hole in the center of each of the keyhole mounting locations as shown.
Step 6: If you are certain there is a stud behind the wall surface, drive the supplied screw through the wall and into the stud as shown in the illustration below.
Step 7: If there is not a stud behind the wall, install the wall anchor as shown in the illustration below.
Step 8: Tighten the screws into the stud or wall anchor and leave 1/4” of the screw head protruding from the wall.
Step 9: Install the rubber bumpers to the corners on the back of each speaker.
Step 10: Connect the speaker wires to the speaker.
Step 11: Line up the keyhole slots on the back of the speaker so the screw heads pass through the large center hole then slide the speaker down.
Step 12: Pull on the speaker gently to be sure that the screws and brackets are properly aligned and attached to the wall securely.
1/4”
Wall Stud Installation
Hollow Wall Installation
Optional Wall Mounting Method
In addition to the flush keyhole mounts, your speakers are also supplied with dual
8