Linksys PAP2-NA manual Frequently Asked Questions, Ethernet LED does not light up

Page 22

Phone Adapter with 2 Ports for Voice-over-IP

5.The Power LED does not light up or lights up red. Go through this checklist until your problem is solved:

•Unplug the power adapter from the Phone Adapter. Wait five seconds. Then plug the power adapter into the Phone Adapter again.

•You may be using the wrong power adapter. Make sure the power adapter you are using is the one included with the Phone Adapter.

6.The ETHERNET LED does not light up.

Go through this checklist until your problem is solved:

•Check the cable connecting the Phone Adapter to your router.

•Make sure your network has an active Internet connection. If it does not, follow these instructions to reboot your cable or DSL modem, Phone Adapter, and router:

1.Power off your cable or DSL modem by unplugging its power adapter.

2.Power off the router by unplugging its power adapter.

3.Power off the Phone Adapter by unplugging its power adapter.

4.Wait two minutes, and then power on your cable or DSL modem by plugging its power adapter into an electrical outlet.

5.Wait two minutes, and then power on the router by plugging its power adapter into an electrical outlet.

6.Wait five minutes, and then power on the Phone Adapter by plugging its power adapter into an electrical outlet.

7.Reboot one of your networked computers, and check to see if you have an active Internet connection.

Frequently Asked Questions

How do I make a phone call?

Pick up your phone and dial 1 + area code + phone number. You must dial 1 and then the area code for all calls, even local ones.

Can I make calls if my Internet connection is down?

No. Your high-speed Internet connection must be active when you make Internet phone or fax calls.

Can I make calls while I’m browsing the Internet?

Yes. You can make Internet phone or fax calls while browsing the Internet. However, your web browsing may affect the quality of your telephone call, depending on the amount of upstream data traffic passing through your Internet connection.

Appendix A: Troubleshooting

18

Frequently Asked Questions

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Phone Adapter How to Use this Guide Copyright and TrademarksTable of Contents Back Panel Front PanelWelcome IntroductionWhat’s in this Guide? Introduction What’s in this Guide? Getting to Know the Phone Adapter Back Panel PortsFront Panel LEDs Overview Connecting the Phone AdapterInstructions for Connecting the Phone Adapter Router Phone AdapterConnect the Ethernet Network Cable Wall-Mount Option Placement OptionsStand Option Remove the plate from the Phone Adapter’s bottom panelAccessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Has been enabled or disabled. If Interactive Voice Response Menu121 Enter the network 7932 Enter 1 to enable This feature is protected by a Entering a Password Configuring the Settings for Your Internet Phone ServiceAppendix a Troubleshooting Common Problems and SolutionsIP address Phone Adapter Internet phone 53 to Application Start and End Protocol IP Address EnableInternet phone 5060 to IP address Phone Adapter Internet phone 69 toIP address Phone Adapter Internet phone 69 to IP address Phone Adapter Internet phone 69 to Frequently Asked Questions Ethernet LED does not light upShared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity Storage TempOperating Humidity 10~90% Non-CondensingAppendix E Warranty Information Limited WarrantyAppendix F Regulatory Information This product complies with Canadian ICES-003Appendix G Contact Information Linksys
Related manuals
Manual 33 pages 13.27 Kb
Top Page Image Contents