Linksys PAP2-NA manual Connecting the Phone Adapter, Overview, Router Phone Adapter

Page 9

Phone Adapter with 2 Ports for Voice-over-IP

Chapter 3: Connecting the Phone Adapter

Overview

This chapter gives instructions on how to connect the Phone Adapter to your network and telephones or fax machines. Shown below is a connection diagram displaying a typical setup.

Internet

Cable/DSL

Router

Phone Adapter

Telephone

 

Modem

 

 

 

Figure 3-1: Connect the Phone Adapter to Your Network and Telephone

This chapter also describes the Phone Adapter’s placement options. You can place it flat on a surface, attach the Phone Adapter’s base so it can stand in place, or mount the Phone Adapter on a wall.

Instructions for Connecting the Phone Adapter

If you already have an account set up with your Internet phone service provider, then proceed to step 1.

If you do not have an account set up with your Internet phone service provider, then go to your provider’s website and sign up for service. After you have set up an account, proceed to step 1.

1.Using a telephone cable, connect your telephone to the PHONE 1 port of the Phone Adapter.

2.If you have a second Internet service account, then connect another telephone or a fax machine to the PHONE 2 port of the Phone Adapter.

IMPORTANT: The Phone Adapter includes a ringer (ring signal generator), which is a source of hazardous voltage. When the ringer is activated by an incoming call, do not touch the Phone port wires, the wires of a cable connected to either of the Phone ports, or the internal circuitry of the Phone Adapter.

IMPORTANT: Do not connect either of the Phone ports to a telephone wall jack. Make sure you only connect a telephone or fax machine to either of the Phone ports. Otherwise, the Phone Adapter or the telephone wiring in your home or office may be damaged.

Figure 3-2: Connect the RJ-11 Telephone Cable

Chapter 3: Connecting the Phone Adapter

5

Overview

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Phone Adapter Copyright and Trademarks How to Use this GuideTable of Contents Front Panel Back PanelIntroduction WelcomeWhat’s in this Guide? Introduction What’s in this Guide? Back Panel Ports Getting to Know the Phone AdapterFront Panel LEDs Instructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview Router Phone AdapterConnect the Ethernet Network Cable Stand Option Placement OptionsWall-Mount Option Remove the plate from the Phone Adapter’s bottom panelUsing the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Interactive Voice Response Menu Has been enabled or disabled. If121 Enter the network 7932 Enter 1 to enable This feature is protected by a Configuring the Settings for Your Internet Phone Service Entering a PasswordCommon Problems and Solutions Appendix a TroubleshootingInternet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toIP address Phone Adapter Internet phone 69 to IP address Phone Adapter Internet phone 69 to Ethernet LED does not light up Frequently Asked QuestionsAppendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Operating Humidity Storage TempStorage Humidity 10~90% Non-CondensingLimited Warranty Appendix E Warranty InformationThis product complies with Canadian ICES-003 Appendix F Regulatory InformationLinksys Appendix G Contact Information
Related manuals
Manual 33 pages 13.27 Kb
Top Page Image Contents