Linksys EFG80 manual Using the Instant GigaDrive’s Setup Wizard

Page 8

Instant GigaDriveTM Series

Chapter 4: Using the Instant GigaDrive’s Setup Wizard

Now that everything is connected and powered on, you are ready to configure the Instant GigaDrive™ so that it is accessible to the users on your network. You will have to run the Instant GigaDrive’s Setup Wizard on your PC to access the Instant GigaDrive’s Quick Setup feature. To run the Setup Wizard on your Windows 98, Me, NT 4.0, 2000, or XP PC, follow the instructions below.

1.Insert the Setup Wizard CD-ROM into your PC’s CD-ROM drive.

2.An autorun menu should appear a few seconds after you insert the CD into your CD-ROM drive. If the autorun menu does not appear after a minute, click the Start button, select Run, type D:\SetupUtility.exe (where D is the letter of your CD-ROM drive) into the Open window and press Enter. The autorun menu appears as shown in Figure 4-1.

Figure 4-1

EtherFast® Network Attached Storage

This Welcome screen provides you with four options in the buttons along the right side of the screen. The first button is the Setup button. Click this button to continue with the setup procedure. The second button is the User Guide button. The third button, Linksys Web, connects you to the Linksys web site if you have an active Internet connection. Lastly, clicking the Exit button will exit the Setup Wizard.

The remainder of this chapter addresses the setup procedure you would follow by clicking the Setup button.

3.From the following screen, shown in Figure 4-2, the Setup Wizard will automatically search for any Instant GigaDrive™ currently on your network or attached to your PC. If it fails to detect the Instant GigaDrive™ or if an Instant GigaDrive™ has been installed since the Setup Wizard’s last search, click Search Again to locate the Instant GigaDrive™.

Figure 4-2

9

10

Page 7 Page 9
Image 8
Page 7 Page 9
Contents EtherFast Network Attached Storage Copyright & Trademarks Table of Contents Features Package ContentsIntroduction Minimum RequirementsInstant GigaDrive’s Rear Panel Instant GigaDrive’s Front PanelLAN Beeper CodesOverview Installing the Instant GigaDriveStep-by-Step Installation Using the Instant GigaDrive’s Setup Wizard Instant GigaDriveTM Series Instant GigaDriveTM Series Instant GigaDriveTM Series Home Tab User Log Home Tab Disk 1/DiskUser Password Tab Administration Tab LANAdministration Tab System Enable GigaDrive NameComment WorkGroupAdministration Tab Users Administration Tab Status Information SystemPrinter DiskAdministration Tab Group Administration Tab SharesAdministration Tab Backup Administration Tab DiskAdministration Tab Upgrade Appendix a Troubleshooting Instant GigaDrive Utility can’t find the Instant GigaDriveAppendix B Installing a Second Hard Drive Figure B-1Figure B-6 Appendix C Setting Up the Built-in PrintServer Figure C-1Figure C-7 Appendix D Glossary Figure C-11Instant GigaDriveTM Series Instant GigaDriveTM Series Appendix E Specifications EnvironmentalAppendix F Contact and Returns Information
Top Page Image Contents