Linksys EFG80 manual Appendix B Installing a Second Hard Drive, Figure B-1

Page 23

Instant GigaDriveTM Series

Appendix B: Installing a Second Hard Drive

Important: This GigaDrive supports IDE Ultra DMA (or UDMA) hard drives with a throughput of 33 - 66 Mbps (ATA/33, ATA/66) and a rotation speed of 5400 or 7200 rpms.

When you’re ready to install a second hard drive into the GigaDrive, follow these directions:

1.Power down the GigaDrive by pressing the switch on the back. Then, unplug the Gigadrive.

2.Unlock the second drive bay, as shown in Figure B-1. This bay is empty and is where your new drive will reside.

Figure B-1

3.Make sure that your hard drive’s jumpers “Master/Slave” settings are set to “Cable Select” before putting it in the drive tray. For instructions on your hard drive’s jumper settings, refer to the documentation that came with your hard drive.

4.Attach the IDE cable from the drive tray to your hard drive, as shown in Figure B-2. The IDE cable is the wider of the two cables in the drive tray. Be sure to plug this securely into your hard drive.

Figure B-2

EtherFast® Network Attached Storage

5.Attach the power cable from the drive tray to your hard drive, as shown in Figure B-3. The power cable is the smaller of the two cables in the drive tray. Be sure to plug this secure- ly into your hard drive.

Figure B-3

6.Review the connections. It should look like the image in Figure B-4. You will want to make sure these connections are tight before securing the drive to the tray.

Figure B-4

7.Insert a screw through the tray’s left side, as shown in Figure B-5, and into your drive. Tighten it to secure the drive to the tray on the left.

Figure B-5

39

40

Page 22 Page 24
Image 23
Page 22 Page 24
Contents EtherFast Network Attached Storage Copyright & Trademarks Table of Contents Minimum Requirements FeaturesPackage Contents IntroductionInstant GigaDrive’s Front Panel Instant GigaDrive’s Rear PanelBeeper Codes LANOverview Installing the Instant GigaDriveStep-by-Step Installation Using the Instant GigaDrive’s Setup Wizard Instant GigaDriveTM Series Instant GigaDriveTM Series Instant GigaDriveTM Series Home Tab Disk 1/Disk Home Tab User LogAdministration Tab LAN User Password TabAdministration Tab System WorkGroup EnableGigaDrive Name CommentAdministration Tab Users System Administration Tab Status InformationDisk PrinterAdministration Tab Shares Administration Tab GroupAdministration Tab Disk Administration Tab BackupAdministration Tab Upgrade Instant GigaDrive Utility can’t find the Instant GigaDrive Appendix a TroubleshootingFigure B-1 Appendix B Installing a Second Hard DriveFigure B-6 Figure C-1 Appendix C Setting Up the Built-in PrintServerFigure C-7 Figure C-11 Appendix D GlossaryInstant GigaDriveTM Series Instant GigaDriveTM Series Environmental Appendix E SpecificationsAppendix F Contact and Returns Information
Top Page Image Contents