Airlink101 AWLL3055 user manual Configuring General Settings

Page 13

3.1 Configuring General Settings

Click Change to configure the adapter’s General Connection Setting.

Channel: This setting is for Access Point Mode only.

Tx Rate: Select the desired transmission rate, or leave the default setting of Auto to allow the adapter to automatically select the optimum rate.

SSID: You can manually enter the SSID of the wireless router/access point you wish to connect to.

Any (check box): Allows you to connect to any available wireless router/access point. (Check this box if you’re trying to connect to a public hot spot and don’t know the SSID).

Network Type: Choose from Infrastructure (for connecting to a wireless router/access point) or Ad-Hoc(for computer-to-computer networking, bypassing the wireless router/access point).

Encryption: Choose from Disable WEP, or Enable WEP.

Authentication Mode: Choose from Auto (recommended), Open System, or Shared Key.

Click Apply to save the changes.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 802.11g USB Adapter with +10dBi Antenna Table of Contents FCC Caution Interference StatementPackage Contents FeaturesIntroduction Install Utility Software Installation ProceduresClick Install Driver and Utility from the Setup menu Page Page Select Install the software automatically and click Next Install DriverConfiguring USB Adapter as a Wireless Client Page Point Page Configuring General Settings Configuring Encryption Security Page Click on WPA Encryption Setting and click Change Configuring Profile Advanced Settings Information Configuring Access Point Configuring USB Adapter as an Access PointChannel Page Authentication Mode select from Open System or Shared Key Configuring MAC Address Filter Filter Type Appendix For Windows 98SE/ME Page Technical Support
Top Page Image Contents