Alloy Computer Products WDS2454AP manual

Page 13

Wireless LAN Settings: to configure the wireless network settings.

ØWireless Network Name (SSID): SSID is an ASCII string up to 32 characters that is used to identify the WLAN and prevents the unintentional merging of two co-located WLANs. The SSID value must be the same in all stations and AP’s in the extended WLAN.

ØBand: you can select to change the radio band to mixed mode, G-only or B-only, a window will pop up to change the policy.

Mixed mode: Supports both 802.11g and 802.11b clients.

G-only:Only supports 802.11g clients.

B-only:Only supports 802.11b clients.

ØRadio Channel: there are 14 channels available due to different Regulatory Domains. The channels differ from country to country; select the channel to be used.

ØBroadcast SSID: when this function is enabled the access point will not broadcast the units SSID to wireless clients.

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents WDS2454AP USA-FCC Federal Communications Commission statement Regulatory Information/disclaimersFCC Radio Frequency Exposure statement FCC Interference StatementProtection requirements for health and safety Article 3.1a Safety InformationCE Mark Warning Effective use of the radio spectrum ArticleTable of Contents About this Guide Unpacking and Setup Hardware Instalation Check the installation Connecting to your office LAN Switch or HubConfiguring the Wireless LAN Access Point Page Page II. Wireless Settings LAN SetupPage III. WDS Links Access Control List II. Radius Server Group Key Setting III. Wired Equivalent Privacy WEPWi-Fi Protected Access WPA IV .1x SecurityStation II. Wireless Statistics III. Event Report II. Access Points Wireless ClientsPage Page II. Lock Access Point Change PasswordGeneral Technical SpecificationsPhysical and Environmental
Top Page Image Contents