Alloy Computer Products WDS2454AP manual LAN Setup, II. Wireless Settings

Page 12

Network

The Network Section is used to configure the IP address of the unit, Wireless settings and the WDS Links of the Access Point.

I.LAN Setup

The LAN Setup function is used to configure the basic LAN settings:

Dynamic (DHCP Client): Select Dynamic for dynamic IP address allocation from a DHCP Server.

Static IP: Select Static to configure an IP Address, Subnet Mask and Gateway for the Access Point.

II.Wireless Settings

The wireless settings screen contains two sections Radio Settings and Wireless LAN.

Radio Settings: to configure the Regulatory Domain settings.

ØRegulatory Domain: Please select the appropriate regulatory domain for your country.

Click on the “change region” button and a window will pop out, select the region in which you are using this AP.

8

Page 11 Page 13
Image 12
Page 11 Page 13
Contents WDS2454AP Regulatory Information/disclaimers USA-FCC Federal Communications Commission statementFCC Radio Frequency Exposure statement FCC Interference StatementSafety Information Protection requirements for health and safety Article 3.1aCE Mark Warning Effective use of the radio spectrum ArticleTable of Contents About this Guide Unpacking and Setup Hardware Instalation Connecting to your office LAN Switch or Hub Check the installationConfiguring the Wireless LAN Access Point Page Page LAN Setup II. Wireless SettingsPage III. WDS Links Access Control List II. Radius Server III. Wired Equivalent Privacy WEP Group Key SettingWi-Fi Protected Access WPA IV .1x SecurityStation II. Wireless Statistics III. Event Report Wireless Clients II. Access PointsPage Page Change Password II. Lock Access PointTechnical Specifications GeneralPhysical and Environmental
Top Page Image Contents