Alloy Computer Products WDS2454AP manual

Page 23

When uploading the file to the AP, do not power off the AP until the “Firmware Upgrade

Complete” screen appears.

Press the “Reset” button on the rear panel of the AP, to reset to unit back to factory default.

19

Image 23

Contents WDS2454AP FCC Interference Statement Regulatory Information/disclaimersUSA-FCC Federal Communications Commission statement FCC Radio Frequency Exposure statementEffective use of the radio spectrum Article Safety InformationProtection requirements for health and safety Article 3.1a CE Mark WarningTable of Contents About this Guide Unpacking and Setup Hardware Instalation Check the installation Connecting to your office LAN Switch or HubConfiguring the Wireless LAN Access Point Page Page II. Wireless Settings LAN SetupPage III. WDS Links Access Control List II. Radius Server IV .1x Security III. Wired Equivalent Privacy WEPGroup Key Setting Wi-Fi Protected Access WPAStation II. Wireless Statistics III. Event Report II. Access Points Wireless ClientsPage Page II. Lock Access Point Change PasswordPhysical and Environmental Technical SpecificationsGeneral