LED Status

SW1 Setting:

SW1 Key	1	2	3	4	5

RS-232	ON	OFF	OFF	-	-

RS-422	OFF	OFF	OFF	-	-

RS-485	OFF	ON	ON	-	-

Normal	-	-	-	OFF	OFF

DHCP				OFF	ON

Default				ON	OFF

Console				ON	ON

Normal: Aport is in Normal Operation Mode

DHCP: Network IP Address is assigned by DHCP Server

Default: All the settings are reset to Factory Default.

Console: COM1 serial port is served as console port. User can use ACSII command to configure BWS-136 via COM1 port. Please refer to Appendix I for the ASCII command

Changing the switch settings will not be effective until system reboot by pressing RESET button

BWS-136 User Manual_amend.doc

- 9 -

The LED provides the BWS-136 operation information. The LED status is described as follow:

Power LED: Power LED keeps ON if power (+9VDC to +40VDC) is correctly input to BWS-136.

Ready LED: Ready LED keeps ON when Aport 211 firmware is ready for operation. Ready LED will be flash when Aport 211 in Serial Console mode (SW1 key 4 and key 5 are ON) or Telnet Console mode (Telnet Console port:5001 are connected) Link/Act LED: Link and Activity LED will turn ON when the Ethernet cable is connected. When there is network data traffic, this LED will be flash.

RX/TX LED: The RX/TX LED is a dual color LED that indicates the serial data traffic. In RS-232 mode, the Yellow LED stands for transmitting data and Green LED means receiving data. In RS-422/485 mode, the Yellow LED stands for receiving data and Green LED means transmitting data.

BWS-136 User Manual_amend.doc

- 10 -