Altinex MT106-101 manual Command Format CnUi, Input 640x480 Output Ntsc C02, SIGCi, Clr, + or

MULTI-TASKER

Ui = Unit ID (i = # from 0 to 9) (refer to the MT100-100 user’s guide for explanation)

Example:

If one Scan Doubler Card is in slot #2 of unit 3. Send the command [VERC2U3], and the Multi-Tasker™ Basic Enclosure will return the following:

MT106-101 690-0155-003

MT106-101 = card type

690-0155-003 = software version

2.[C]

This command receives the status of the card.

Command Format: [CnUi]

Cn = card ID (n = a slot # from 1 to 19) (1-8 for MT100-101 or 1-4 for MT100-106)

Ui = unit id (i = 0 to 9) (refer to the MT100-100 user’s guide for explanation)

Example:

If there is one MT106-101 card in slot #2 of unit 3 set for NTSC outputs, sending the command [C2U3] to the Multi-Tasker™ will yield the following feedback:

INPUT: 640x480; OUTPUT: NTSC C02

INPUT: 640x480	= Input resolution
OUTPUT: NTSC	= Output mode
C02	= card is in slot 2

If there is no card in slot #2 of unit 3, sending the [C2U3] command will not return any feedback from either card.

3.[SIGCi]

The Signal Present command tests for the presence of a signal on the input. After sending the command, the feedback will be either "1" signifying a signal is present, or "0" indicating no signal was detected.

Ci = card number

Example:

To check for the presence of an input signal on card 4, send the command [SIGC4] and verify

feedback of "1" or "0".

4.[CLR]

This command resets the card configuration to factory defaults.

Command Format: [CLRCi]

Ci = card ID (n = a slot # from 1 to 19) (1-8 for MT100-101 or 1-4 for MT100-106)

Example:

There is an MT106-101 in slot 4 of unit 0. All controls are set to various levels and the output is in PAL mode. Sending the command [CLRC4] will set the level controls to their default values and place the output in NTSC format.

5.[ON]

The ON command selects one of four possible input sources to connect to the output.

INPUT Number		INPUT Signal
	( n )	Name
	0	S-Video
	1	C-Video #1
	2	C-Video #2
	3	C-Video #3
Command Format: [ONnCiUy]
n	= value from 0 to 3
Ci	= card ID (i = slot number)
Uy	= unit id (i = 0 to 9) (refer to the MT100-100
	user’s guide for explanation)

Example:

Connect the S-Video signal input on the MT106-101 located in slot 4 of unit ID 2 to the VGA output connector.

[ON0C4U2]

6. [ + ] or [ - ]

These commands allow the user to increase or decrease the value of the selected attribute. They must be used immediately following one of the following STATUS commands.

8