D-Link DCM-201 manual Add New Hardware Wizard screen appears. Click Finish

Page 25

Installing the Software Drivers (Windows Me OS) (continued)

c The Add New Hardware Wizard screen appears. Click Finish.

3 Select Specify the location of the driver (Advanced) and click Next.

25

Image 25

Contents Link DCM-201 Contents Package Contents System Requirements for Configuration Prepare Your Workspace for the Cable Modem Installation Local Cable Network ServiceBefore installing the modem Serial Number S/N RF and ETH MACPrepare Your Workspace for the Cable Modem Installation Introduction Decide Which Installation Process to Use FeaturesInstalling the Cable Modem Using the Ethernet Port Verify the TCP/IP Protocol Configuration To configure TCP/IP on your Windows XP and Windows 2000 PC To configure TCP/IP on your Windows NT 4.0 PC Configuring TCP/IP on a Macintosh ComputerTo configure TCP/IP on a Macintosh Troubleshooting the Ethernet Installation Connecting the Cable ModemProblem I cannot access my e-mail or Internet service Click Properties Page Installing the Cable Modem Using the USB Port To install the hardware Installing the Hardware Cable Modem and Power AdapterInstalling the Software Drivers Windows XP OS Installing the Software DriversInstalling the Software Drivers Windows XP OS Installing the Software Drivers Windows 2000 OS Installing the Software Drivers Windows 2000 OS Click Finish to continue Installing the Software Drivers Windows 2000 OS Installing the Software Drivers Windows Me OS Add New Hardware Wizard screen appears. Click Finish Installing the Software Drivers Windows Me OS Troubleshooting the USB Installation Troubleshooting the USB Installation Page Front Panel LEDs Cable Modem Front and Rear PanelsWhat the LED Activity Means PowerCable StatusPower Back Panel ConnectorsTechnical Specifications Link Technical Support over the Telephone 877 Contacting Technical SupportLink Technical Support over the Internet Warranty and Registration Page 01/21/2003