D-Link DI-701 manual Getting Started Telnet, Command

Getting Started (Telnet)

1.Power up the DI-701. Wait 30-90 seconds for it to boot up.

2.In Windows 98 start Telnet by clicking StartàRun, type “telnet 192.168.0.1 333” and press enter. If the local port of the DI-701 is set to something other than “192.168.0.1” (the factory default), then simply use that IP address instead.

The following information will appear:

IP Sharing for Cable Modem/ADSL Modem/Ethernet

BIOS Version: 1.00 (1999/10/06)

©Copyrights 1999, all rights reserved.

SRAM Test			O
WAN	NIC	Test	O	MAC	Address:	00	E8	80	C8	20	93
LAN	NIC	Test	O	MAC	Address:	00	E8	80	C8	00	12

Internet SOAR is ready

System starts up

Welcome to SOAR 1.01

Administrator password:

1.No password is required the first time you log in. Press <ENTER> to enter Configure mode. The screen prompts you for the following command.

command>

2.Type the SET command to configure your DI-701. Press <ENTER> if you agree with the default value, enter a new value and press <ENTER> if you do not, or press <ESC> to escape without saving. The SET command will list all configurable parameters in sequence. For detailed descriptions of each parameter, read the “DI-701 Setup Software” section which uses analogous parameters.

3.Refer to the “Terminal Commands” section for a detailed description of terminal commands.

25