Motorola VT1000v warranty Installation With a Single Computer

Page 14

Broadband

Modem

Ethernet port

WAN

Motorola voice terminal

 

 

 

 

 

LINE 1

 

PC

 

 

 

 

 

Ethernet port

Phone

Computer

Installation With A Single Computer

1Be sure the Motorola voice terminal is unplugged. Be sure power is off to your broadband modem (cable or DSL) and computer.

2Connect one end of an Ethernet cable (RJ-45) to the Ethernet connector on your broadband modem. Connect the other end of this Ethernet cable to the WAN connector on the Motorola voice terminal.

3Connect one end of another Ethernet cable to the PC connector on the Motorola voice terminal. Connect the other end of this Ethernet cable to the Ethernet connector on the computer.

4Connect a telephone to the LINE 1 connector using a phone wire (RJ-11). For a VT1005v only, you can connect a second telephone to the LINE 2 connector.

5Power on the broadband modem, following the instructions provided with your modem. Wait about two minutes for it to boot.

6Plug the AC power adapter to the POWER connector on your Motorola voice terminal and the electrical outlet. This turns your Motorola voice terminal on. You do not need to unplug it when not in use.

7Check that the POWER light on your Motorola voice terminal turns on solid green. Wait about two minutes for the Motorola voice terminal to boot.

8

Page 13 Page 15
Image 14
Page 13 Page 15
Contents User Guide VT1000v Series Voice Terminal Safety and Regulatory Information FCC ComplianceCanadian Compliance FCC Declaration of ConformityInternational Declaration of Conformity Contents Page Introduction VT1000v Series Voice Terminal User GuideSample Configuration Without a Home Network InternetSample Configuration With a Home Network Motorola voice terminalFront and Rear Panel Type Connects ToBefore You Begin DescriptionPrecautions Signing Up for ServiceInstallation Installation With a Single Computer VT1000v Series Voice Terminal User Guide Installation With a Home Network Not need to unplug it when not in useVT1000v Series Voice Terminal User Guide Connecting a Computer to Display Configuration Pages Basic Configuration Page If you cannot a hear a dial tone, try the following Advanced Configuration Field or Button DescriptionChanges. The message This will require a reboot Status Field DescriptionVT1000v Series Voice Terminal User Guide FieldDescription Help Contact Information TroubleshootingProblem Possible Solutions Glossary BroadbandVT1000v Series Voice Terminal User Guide Software License and Warranty LicenseWarranty Information Visit our website at
Top Page Image Contents