Motorola VT1000v warranty Connecting a Computer to Display Configuration Pages

Page 18

Connecting a Computer to Display the

Configuration Pages

For an Installation With A Home Network only, you need to connect a computer with DHCP enabled to the Motorola voice terminal to display the configuration pages. For information about enabling DHCP, refer to your operating system documentation.

If you performed an Installation With A Single Computer, a computer is already connected to the Motorola voice terminal.

To connect a computer to the back of the Motorola voice terminal:

1Connect one end of an Ethernet cable to the PC connector on the Motorola voice terminal.

2Connect the other end of the Ethernet cable to the Ethernet connector on a computer.

3Power up the computer.

12

Image 18

Contents User Guide VT1000v Series Voice Terminal Safety and Regulatory Information FCC ComplianceCanadian Compliance FCC Declaration of ConformityInternational Declaration of Conformity Contents Page Introduction VT1000v Series Voice Terminal User GuideSample Configuration Without a Home Network InternetSample Configuration With a Home Network Motorola voice terminalFront and Rear Panel Type Connects ToBefore You Begin DescriptionPrecautions Signing Up for ServiceInstallation Installation With a Single Computer VT1000v Series Voice Terminal User Guide Installation With a Home Network Not need to unplug it when not in useVT1000v Series Voice Terminal User Guide Connecting a Computer to Display Configuration Pages Basic Configuration Page If you cannot a hear a dial tone, try the following Advanced Configuration Field or Button DescriptionChanges. The message This will require a reboot Status Field DescriptionVT1000v Series Voice Terminal User Guide FieldDescription Help Troubleshooting Problem Possible SolutionsContact Information Glossary BroadbandVT1000v Series Voice Terminal User Guide Software License and Warranty LicenseWarranty Information Visit our website at