Motorola operation manual SG2-DRT-3X installed in SG2000

Page 10

10STARLINE

Figure 11 illustrates the SG2000 equipped with an SG2-RPM/C, the E-pack cover removed, the ICS locations, proper cable routing and installed SG2-DRT-3X.

Figure 11

SG2-DRT-3X installed in SG2000

ICS connections

5Install an SG2-DR-3X input board in each selected ICS location. The ICS locations on the left are for ports 1 and 3 and the locations on the right are for ports 2 and 4.

6Nest the attached cables between the components on the E-pack and toward the PIC cable and status monitoring cable (optional).

7Position the cover on the E-pack and route the cables through the bottom opening following the PIC cable.

SG2-DRT-3X Installation Sheet

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Before You Begin SG2-DRT-3X Installation SheetRelated Documentation Document Conventions AsteriskSG2-DRT-3X block diagram SG2-DRT-3X transmitterDescription KeyFeatureSG2-DRT-3X side view and laser warning label SG2440-DR-3X return configuration Installing the SG2-DRT-3X in the SG2440 NodeSG2440-DR-3X return board SG2440 lid Illustrates a properly installed and cabled SG2-DRT-3X Installing the SG2-DRT-3X in the SG2000 Node SG2-DRT-3X cabling for combined configurationSG2 ICS board SG2-DRT-3X Installation Sheet Illustrates the ICS boardSG2000 optical transmitter B and a locations JP1SG2-DRT-3X installed in SG2000 Page SG2-DRT-3X Dwdm Models SpecificationsParameter Specification ModelIf You Need Help SG2-DRT-3X Cwdm ModelsModel Description Special Symbols That Might Appear on the Equipment EMC Standards
Top Page Image Contents