Motorola operation manual Illustrates a properly installed and cabled SG2-DRT-3X

Page 6

6STARLINE

TP XMTR A and Pad XMTR A are not used. It is not necessary to pad the XMTR A location as no signal is present.

8Close the housing and use a torque wrench to progressively tighten the housing bolts to a final torque of 12 ft-lbs. in the sequence stamped on the housing lid.

Figure 7 illustrates a properly installed and cabled SG2-DRT-3X.

Figure 7

SG2-DRT-3X installed in SG2440

SG2-DRT-3X Installation Sheet

Image 6

Contents Before You Begin SG2-DRT-3X Installation SheetRelated Documentation Document Conventions AsteriskSG2-DRT-3X block diagram SG2-DRT-3X transmitterKeyFeature DescriptionSG2-DRT-3X side view and laser warning label Installing the SG2-DRT-3X in the SG2440 Node SG2440-DR-3X return configurationSG2440-DR-3X return board SG2440 lid Illustrates a properly installed and cabled SG2-DRT-3X Installing the SG2-DRT-3X in the SG2000 Node SG2-DRT-3X cabling for combined configurationSG2 ICS board SG2-DRT-3X Installation Sheet Illustrates the ICS boardSG2000 optical transmitter B and a locations JP1SG2-DRT-3X installed in SG2000 Page SG2-DRT-3X Dwdm Models SpecificationsParameter Specification ModelSG2-DRT-3X Cwdm Models If You Need HelpModel Description Special Symbols That Might Appear on the Equipment EMC Standards