3Com RMON-EMP-3 Using the DIP Switch to Assign Networks, DIP Switch Location

Using the DIP Switch to Assign Networks

If you have an unmanaged hub, use the DIP switch on the module to assign networks to the RMON MultiProbe Module interfaces. However, the DIP switch settings are ignored if the following two conditions are met:

❑A network management module is installed in the hub.

❑The master management module has DIP_CONFIGURATION disabled.

The RMON MultiProbe Module contains an 8-position DIP switch (SW1). This DIP switch allows you to configure and enable the three RMON MultiProbe Module interfaces to the corresponding Ethernet networks.

Figure 3-8 shows the DIP switch location on the module

.

								SW1
Dip Switches
On	0
	1
Off			1	2	3	4 5	6		7	8
		NOT USED NOT USED CH1EN CH2EN CH3EN NOT USED NOT USED NOT USED

Backplane DIN Connector

Figure 3-8. DIP Switch Location

Configuring the Module 3 - 33