Asus tpm manual Serial ATA 3.0 Gb/s connectors 7-pin SATA3G1-4, Configuration Sata Mode Selection

6.Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_1-4)

These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via Serial ATA 3.0 Gb/s signal cables.

P8H61-M2/TPM/SI R2.0

SATA3G_3

SATA3G_1

GND

RSATA_TXP3

RSATA_TXN3

GND

RSATA_RXN3

RSATA_RXP3

GND

GND

RSATA_TXP1

RSATA_TXN1

GND

RSATA_RXN1

RSATA_RXP1

GND

SATA3G_4

SATA3G_2

GND

RSATA_RXP4

RSATA_RXN4

GND

RSATA_TXN4

RSATA_TXP4

GND

GND

RSATA_RXP2

RSATA_RXN2

GND

RSATA_TXN2

RSATA_TXP2

GND

P8H61-M2/TPM/SI R2.0 Intel® SATA 3.0Gb/s connectors

• You must install Windows® XP Service Pack 3 or later version before using Serial ATA hard disk drives.

•Due to H61 Chipset limitation, AHCI Mode only works on Windows® Vista / Windows® 7. Please use IDE Mode on Windows® XP.

•[IDE] is the default SATA type. Under Windows® XP, there is no need to change the SATA type.

•To configure the SATA type in BIOS, click Advanced Mode > Advanced tab > SATA

Configuration > SATA Mode Selection.

•When using hot-plug and NCQ on Windows® Vista / Windows® 7, set the SATA Mode Selection item in the BIOS to [AHCI]. See section 2.5.4 SATA Configuration for details.

7.Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

P8H61-M2/TPM/SI R2.0

AGND	NC	SENSE1 RETUR	SENSE2 RETUR
AAFP
PORT1 L	PORT1 R	PORT2 R	SENSE SEND PORT2 L

HD-audio-compliant

pin definition

AGND NC NC NC

PIN 1

Line out_L

NC

Line out_R

MICPWR

MIC2

Legacy AC’97

compliant definition

P8H61-M2/TPM/SI R2.0 Front panel audio connector

• We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard’s high-definition audio capability.

•If you want to connect a high-definition front panel audio module to this connector, set the Front Panel Type item in the BIOS setup to [HD]. If you want to connect an AC'97 front panel audio module to this connector, set the item to [AC97]. By default, this connector is set to [HD]. See section 2.5.7 Onboard Devices Configuration for details.

Chapter 1: Product introduction 1-25

E7361_P8H61-M2-TPM-SI R2.0_Manua25 25

5/16/12 1:44:30 PM