Asus WL-330G manual ProblemAction

Page 69

ProblemAction

The ASUS Pocket Wireless AP Power LED continuously blinks for more than a minute.

A wireless client wants to connect to the ASUS Pocket Wireless AP but can not get the correct IP from the DHCP server. (The ASUS Pocket Wireless AP has an enabled DHCP.)

Turn off the ASUS Pocket Wireless AP. Turn the device again and observe if the Power LED stops blinking.

If the blinking continues, you need to restore the ASUS Pocket Wireless AP firmware. Use the Firmware Restoration utility to restore or update the ASUS Pocket Wireless AP firmware.

Make sure the DHCP server is working properly. Some DHCP servers can only assign one IP address at a time. In this case, assign a fixed IP address to your ASUS Pocket Wireless AP.

ASUS Pocket Wireless Access Point (WL-330g)

A-5

Image 69

Contents 54Mbps Pocket Wireless Access Point WL-330g User Guide E1539 First Edition May Contents Appendix Troubleshooting Federal Communications Commission Statement Safety Information Safety statementsRegulatory Information/Disclaimers MPE StatementRF Exposure How this guide is organized About this guideConventions used in this guide This guide contains the following partsASUSTeK Computer INC. Asia-Pacific Asus contact informationAsus Computer International America Asus Computer GmbH Germany and AustriaWL-330g specifications summary Chapter Welcome Package contentsTop view FeaturesBottom view Rear viewMounting hook. Use the mounting Modes AP Access Point mode EA Ethernet adapter mode LED indicatorsAccess Point mode Recommended network settingsAd-hoc network Ethernet adapter modeAsus Pocket Wireless AP A single IP bridge environmentSingle IP address Hardware installation Device installation System requirementsBefore you proceed Using DC power Using USB bus power Operating range PlacementWall mounting RangeSite survey Roaming informationConfiguration Installing the utilities Other support CD optionsDevice utilities are copied to your computer Launching the Wireless Setting Utility Wireless Setting UtilityFrom the support CD From the Windows desktopTo set the device as an access point AP Using the Wireless Setting UtilityAsus Pocket Wireless Access Point WL-330g Specified settings are applied to the device To set the device as an Ethernet adapter Wireless network icon indications Icon Indicates that Asus Pocket Wireless Access Point WL-330g Web Configuration utility Adjusting the TCP/IP settingsTo adjust the TCP/IP settings of the network adapter Set the Subnet Mask to 255.255.255.0. Click OK when finished Launching the Web Configuration utility Using the Wireless Setting UtilityUsing an Internet browser Simple Setup Changing the access point AP configurationConfiguration WPA-PSK Securing your wireless communication using WEP encryption Changing the network settings Access Control Firmware Upgrade Regulation Domain Browser refreshes with the new passwordCH ID Parameter Default value Restoring the default valuesChanging the Ethernet adapter configuration Preamble. See Encryption. See Pass Phrase. See Default Key. SeeAsus Pocket Wireless Access Point WL-330g Station Status Site SurveyTo scan available wireless networks in your location Configuration Asus Pocket Wireless Access Point WL-330g Configuration Asus Pocket Wireless Access Point WL-330g Profile Table Asus Pocket Wireless Access Point WL-330g Configuration Refer to page 3-19 for details Parameter Default valueFirmware Restoration window appears Firmware RestorationUsing the device Replacing the computer Ethernet cables Using the device in a local networkComputers Devices2PPPoE Point-to-Point over Ethernet Appendix Asus Pocket Wireless AP does not power up ProblemActionCheck if the Asus Pocket Wireless AP is in Access Point mode Throughput seems slow ProblemAction Appendix