Chapter 7: Console Commands
SAVE
Save settings for next startup. All settings are stored in
RESET
Causes the switch to reboot and reloads all parameters from stored settings. The Ethernet network management interface takes approximately 5 seconds to reboot completely.
SET DEFAULTS
Restore user default settings. A SAVE operation is required to make the changes permanent.
?
HELP
Displays a list of available console commands.
R6000 CONSOLE COMMANDS:
GET | ALL (display all parameters) |
GET | VERSION (display software versions) |
GET[SET] | SYSTEM [A/B] (control all system ports) |
GET[SET] | RACK N [A/B] (control single rack ports) |
GET[SET] | PORT N [A/B] (control single port) |
GET | EVERYRACK (display status for all racks) |
GET | EVERYRACK N (display status for racks 1 thru N) |
GET | POWER N (display power status) |
GET[SET] | IPADDRESS [X.X.X.X] |
GET[SET] | SUBNETMASK [X.X.X.X] |
GET[SET] | GATEWAY [X.X.X.X] |
GET[SET] | PINGREPLY [ON/OFF] |
GET[SET] | SNMPENABLE [ON/OFF] |
GET[SET] | READCOMMUNITYNAME [string] |
GET[SET] | WRITECOMMUNITYNAME [string] |
GET[SET] | WEBENABLE [ON/OFF] |
GET[SET] | WEBPASSWORD [string] |
GET[SET] | WEBTIMEOUT [N] (seconds) |
GET[SET] | WEBPORT [N] |
GET[SET] | TELNETENABLE [ON/OFF] |
GET[SET] | TELNETPASSWORD [string] |
GET[SET] | TELNETTIMEOUT [N] (seconds) |
GET[SET] | TELNETPORT [N] |
GET[SET] | MONITORIP [X.X.X.X] (0.0.0.0 to disable) |
GET[SET] | MONITORMAC [X X X X X X] (X=HEX CHARS) |
GET[SET] | MONITORINTERVAL [N] (1/10 seconds, 0 to disable) |
GET[SET] | MONITORFAILCOUNT [N] (0 to disable) |
GET[SET] | MONITOROKCOUNT [N] (0 = no auto recover) |
GET[SET] | AUTHENTICATIONTRAP [ON/OFF] |
GET[SET] | ALERTTYPE [TRAP/SYSLOG] |
GET[SET] | ADMINIP N [X.X.X.X] (0.0.0.0 to disable an entry) |
GET | ADMINIP (display all administrator IP addresses) |
GET[SET] | MANAGER N [X.X.X.X] (0.0.0.0 to disable an entry) |
GET | MANAGER (display all SNMP managers) |
PING | X.X.X.X (ICMP ECHO to remote host) |
|
|
NBS008A | Page 33 | |
|
|