Chapter 3 Installing the AVS 3120
Configuring Network Settings
Configuring Network Settings
After you have installed the AVS 3120, you must configure the basic network settings by using the set command in the CLI from a console connection. After the basic network settings have been configured, you can perform additional CLI configuration through the network by using an SSH connection.
Additionally, you can configure application acceleration and other features by using the Management Console GUI in a Web browser. For details about using the CLI and Management Console, refer to the Cisco Application Velocity System User Guide.
To configure the basic network settings, follow these steps:
Step 1 Log in to the AVS 3120 from a console connected to the serial port.
Note The default username is fgn, and the password is fineground.
After you log in, the velocity> prompt appears.
Step 2 Enable writing configuration settings with the enable command:
velocity>enable
Step 3 Configure the network interface with the set interface command:
velocity>set interface ip ip netmask mask
where:
ip is the device interface IP address, such as 10.210.10.45
mask is the device interface network mask, such as 255.255.255.0
gw is the gateway address, such as 10.210.2.1
autoneg can be set to on or off, for speed autonegotiation (if off, you must set the speed and duplex settings manually by using the speed and duplex options)
You can view the interface settings by using the show interface command:
velocity>show interface |
|
| |
PHYSICAL INTERFACE eth1 |
|
| |
MAC ADDRESS: 00.0f.f7.75.75.73 |
| ||
Auto Negotiation: on |
| ||
Duplex: full |
|
| |
Speed: 100 |
|
| |
RX: | PKTS=1206954 | BYTES=114173340 | ERRORS=0 |
TX: | PKTS=428072 | BYTES=53566339 | ERRORS=0 |
MTU: | 1500 |
|
|
INTERFACE NUMBERS |
|
| |
IP/NETMASK: 10.210.2.45/255.255.255.0 |
| ||
DEFAULT GATEWAY: | 10.210.2.1 |
| |
Step 4 Configure the DNS server addresses with the set dns command:
velocity>set dns primary ip1 secondary ip2
where:
ip1 is the primary DNS server IP address or name, such as 10.68.226.120 ip2 is the secondary DNS server IP address name, such as 10.68.226.121
| Cisco AVS 3120 Application Velocity System Hardware Installation Guide |