Accton Technology Workgroup-3726M manual Installing the Switch, Package Contents

Page 10

Quick Installation Guide

Installing the Switch

Before installing the switch verify that you have all the items listed under “Package Contents.” If any of the items are missing or damaged, contact your local Accton distributor. Also be sure you have all the necessary tools and cabling before installing the switch. Note that this switch can be installed on any suitably large flat surface or in a standard EIA 19-inch rack. After installing the switch, refer to the Management Guide to set up its more advanced features, such as Spanning Tree Protocol or VLAN port groups.

Package Contents

This package includes:

• CheetahSwitch Workgroup-3726M (Model No. AC-ES3726M)

•

Four rubber foot pads

•

This Quick Installation Guide

•

Rack mount bracket kit

•

Owner registration card

•

AC power cord

 

 

Description of Hardware

The base unit contains 24 10BASE-T/100BASE-TX ports, plus three slots on the rear panel for various modules. A Management Module can be installed in the upper slot on the rear panel (see “Installing a Management Module” on page 4). The lower-left slot can be used for an optional media expansion module or Stacking Module, while the lower-right slot can be used for a media expansion module. Note that the media expansion modules include a Fast Ethernet fiber optic module with two 100BASE-FX (SC type) ports or a one port Gigabit 1000BASE-SX (SC type), or 1000BASE-LX uplink module.

All RJ-45 ports on the base unit operate at 10 or 100 Mbps, and support auto-negotiation of speed, duplex mode (i.e., half or full duplex), and flow control.

The 1000BASE-SX and 1000BASE-LX ports are fixed at 1000 Mbps but auto-negotiate duplex mode. The 100BASE-FX module is fixed at the 100 Mbps, full duplex. All media types can auto-negotiate flow control.

Note that when using auto-negotiation, the speed, transmission mode and flow control can be automatically set if this feature is also supported by the attached device. Otherwise, these items can be manually configured for any connection.

The base unit also includes a display panel for key system and port indications that simplify installation and network troubleshooting.

2

Page 9 Page 11
Image 10
Page 9 Page 11
Contents CheetahSwitch Workgroup-3726M Quick Installation Guide Page CheetahSwitch Workgroup-3726M On-line Registration Accton Technology Corporation Limited Warranty Contents Optional Hardware Modules Introduction Package Contents Installing the SwitchDescription of Hardware Mounting the Switch Installing the SwitchInstalling a Management Module Installing Optional Media and Stacking ModulesConnecting to the Stack’s Backplane Connecting the Switch System Making a Connection to an RJ-45 PortConnecting to a 100BASE-FX Port Powering On the Switch Verifying Port Status Verifying System OperationApplications Product Specifications Base UnitSwitching Criteria ModulesTroubleshooting Diagnosing Switch IndicatorsPower and Cooling Problems InstallationPort and Cable Assignments RJ-45 Port DescriptionCanada Department of Communications Class a EMI CertificationFCC Class a Certification USA Bsmi Class a Taiwan Vcci Class a Compliance JapanCE Mark Declaration of Conformance for EMI and Safety EEC Warnhinweis Faseroptikanschlüsse Optische Sicherheit Safety ComplianceUnderwriters Laboratories Inc. USA Wichtige Sicherheitshinweise Germany Optional Hardware Modules Page AC-ES3726M E012002-R01 F2.476 150200008100A
Top Page Image Contents