Accton Technology CheetaSwitch Workgroup-3726M Verifying Port Status, Verifying System Operation

Page 17

Installing the Switch

Verifying Port Status

Check each connection by viewing the port indicators on the base unit front panel. Their staus is shown in the following table.

LED

S tate

Indication

System

 

 

Power

On

Switch is receiving power.

RDP

On

Redundant power unit on.

Mgmt

On

Management agent operational.

RJ-45 Ports

 

 

Link

On

Port has established a valid network connection.

 

Yellow

Communications have been set to 10 Mbps.

 

Green

Communications have been set to 100 Mbps.

 

Flashing

Port has been manually disabled, or partitioned

 

 

by the system due to excessive errors.

Activity*

On

Traffic is passing through the port.

FDX*

On

Port has been set to full duplex.

FC*

On

Flow control enabled.

Module Ports

 

 

Status

On

A valid module is correctly installed in the slot.

Activity

On

Traffic is passing through the port.

* Use the Mode Select button to select LED display mode.

Verifying System Operation

Verify that the stack has at least one Management Module correctly installed and operating. The “Mgmt” LED on the switch that contains the Management Module should be on, indicating that the module is installed and operating correctly.

Verify that the stack connections are operating correctly. Each switch in the stack has it’s own unique unit ID (a number from 1 to 4) displayed by the front-panel LCD labeled “Switch ID.” If any switch in the stack displays a flashing or unstable unit ID for more than 30 seconds, you should check the following items:

•Reset the stack by powering off all switches and then powering them back on.

•Be sure that all Stacking Modules are correctly installed in each switch’s lower-left slot and the stacking cables are properly attached.

Verify that any optional modules are installed correctly. The Module 1 or Module 2 “Status” LEDs on the switch panel should be on, indicating that the modules are installed and operating correctly.

Verify that all attached devices have a valid connection. The switch monitors the link status for each port. If any device is properly connected to the switch and transmitting a link signal, the Link indicator will light up for the corresponding port. If the Link indicator fails to light when you connect a device to the switch, check the following items:

•Be sure all network cables and connectors are properly attached to the connected device and the switch.

9

Page 16 Page 18
Image 17
Page 16 Page 18
Contents CheetahSwitch Workgroup-3726M Quick Installation Guide Page CheetahSwitch Workgroup-3726M On-line Registration Accton Technology Corporation Limited Warranty Contents Optional Hardware Modules Introduction Description of Hardware Installing the SwitchPackage Contents Installing the Switch Mounting the SwitchInstalling Optional Media and Stacking Modules Installing a Management ModuleConnecting to the Stack’s Backplane Making a Connection to an RJ-45 Port Connecting the Switch SystemConnecting to a 100BASE-FX Port Powering On the Switch Verifying System Operation Verifying Port StatusApplications Base Unit Product SpecificationsModules Switching CriteriaDiagnosing Switch Indicators TroubleshootingInstallation Power and Cooling ProblemsRJ-45 Port Description Port and Cable AssignmentsFCC Class a Certification USA EMI CertificationCanada Department of Communications Class a Bsmi Class a Taiwan Vcci Class a Compliance JapanCE Mark Declaration of Conformance for EMI and Safety EEC Underwriters Laboratories Inc. USA Safety ComplianceWarnhinweis Faseroptikanschlüsse Optische Sicherheit Wichtige Sicherheitshinweise Germany Optional Hardware Modules Page AC-ES3726M E012002-R01 F2.476 150200008100A
Top Page Image Contents