Accton Technology CheetaSwitch Workgroup-3726M manual Connecting to the Stack’s Backplane

Page 13

Installing the Switch

You can install a module as described below:

1. Disconnect power to the switch (the modules are not hot-swappable).

2. Remove the face plate on the appropriate slot by removing the two screws with a flat-head screwdriver.

3.Before opening the package that

contains the module, touch the bag to the switch casing to discharge any potential static electricity.

4.Remove the module from the anti-static shielded bag.

5.Holding the module level, gently push it all the way into the slot along the guide rails, ensuring that it firmly engages with the connector.

6.If you are sure the module is properly mated with the connector, tighten the retainer screws to secure the module in the expansion slot.

The slide-in modules are not hot-swappable. Be sure you power off the switch before installing any of these modules.

Connecting to the Stack’s Backplane

Plug one end of the stack cable (provided with the package) in the “Down” port of the top unit and the other end to the “Up” port of the next unit. Repeat this step for each unit in the stack. Form a simple chain starting at the Down port on the top switch and ending at the Up port on the bottom switch (stacking up to 4 units).

5

Page 12 Page 14
Image 13
Page 12 Page 14
Contents CheetahSwitch Workgroup-3726M Quick Installation Guide Page CheetahSwitch Workgroup-3726M On-line Registration Accton Technology Corporation Limited Warranty Contents Optional Hardware Modules Introduction Package Contents Installing the SwitchDescription of Hardware Installing the Switch Mounting the SwitchInstalling Optional Media and Stacking Modules Installing a Management ModuleConnecting to the Stack’s Backplane Making a Connection to an RJ-45 Port Connecting the Switch SystemConnecting to a 100BASE-FX Port Powering On the Switch Verifying System Operation Verifying Port StatusApplications Base Unit Product SpecificationsModules Switching CriteriaDiagnosing Switch Indicators TroubleshootingInstallation Power and Cooling ProblemsRJ-45 Port Description Port and Cable AssignmentsFCC Class a Certification USA EMI CertificationCanada Department of Communications Class a Bsmi Class a Taiwan Vcci Class a Compliance JapanCE Mark Declaration of Conformance for EMI and Safety EEC Warnhinweis Faseroptikanschlüsse Optische Sicherheit Safety ComplianceUnderwriters Laboratories Inc. USA Wichtige Sicherheitshinweise Germany Optional Hardware Modules Page AC-ES3726M E012002-R01 F2.476 150200008100A
Top Page Image Contents