TRENDnet TW-H6W1IR manual Connecting the Console to the Router, Using the Console

TW-H6W1IR ISDN Remote Router

??9600 baud

??No parity, 8 data bits, 1 start bit, 1 stop bit

??No flow control

Step 2 - Connecting the Console to the Router

A serial cable is included in the TW-H6W1IR package. To connect this cable, plug its nine-pin connector into the 9-pin RS-232 Diagnostic port on the router’s rear panel, then connect the other end to the serial port on the rear of your computer or data terminal.

Please make sure both machines are turned off before making this connection.

After the connection is made, first power on the console. If you are using a PC, run the terminal emulation software at this time. After the PC and the terminal emulation software are up and running, power on the router.

Using the Console

The Console Program is the interface that you will be using to configure your TW-H6W1IR. Several operations that you should be familiar with before you attempt to modify the configuration of your router are listed below:

??Moving the Cursor. Within a menu, use Tab and arrow keys to navigate through different information fields.

??Moving Forward to Another Menu. To move forward to a sub-menu below the current one, use Tab or arrow keys to

16 Installation