Power Cable | Remote Control/ 1 Batteries |
Cleaning Cloth | |
| (Not available in all locations) |
Sold separately
LED Indications |
|
| ||
●:Light is On ◐:Light is Blinking | ○:Light is Off | |||
STAND | LAMP | TEMP | Information | |
BY | ||||
|
|
| ||
● | ○ | ○ | If you press the POWER button on the remote control or projector, the screen | |
appears within 30 seconds. | ||||
|
|
| ||
● | ● | ○ | The projector is in normal operating condition. | |
● | ◐ | ○ | This state appears when the projector is preparing an operation after the POWER button | |
on the projector or the remote control has been pressed. | ||||
|
|
| ||
|
|
| The POWER button is pressed to turn off the projector, and the cooling system is in | |
○ | ◐ | ○ | operation to cool off the inside of the projector. (Lasts for about 1 minute and 30 | |
|
|
| seconds) | |
◐ | ○ | ◐ | Refer to Action 1 below if the cooling fan inside the projector is not in normal operation | |
condition. | ||||
|
|
| ||
○ | ◐ | ◐ | Refer to Action 2 below if the lamp cover protecting the lamp unit is not closed | |
properly. | ||||
|
|
| ||
○ | ○ | ◐ | Power is turned off automatically when temperature inside of the projector goes beyond | |
the control limit. Refer to Action 3. | ||||
|
|
| ||
● | ◐ | ◐ | A problem has occurred when operating the DDP IC in the product. Refer to Action 4. | |
◐ | ◐ | ◐ | A problem has occurred with the operation of the lamp. Refer to Action 5. | |
● | ◐ | ● | The lifetime of the lamp has expired. Refer to Action 6. | |
◐ | ◐ | ○ | The memory in the product is not operating normally. Contact a service center. | |
◐ | ◐ | ● | The power for the product is not operating normally. Contact a service center. | |
◐ | ● | ◐ | A problem has occurred when operating the color wheel in the product. Refer to Action | |
4. | ||||
|
|
| ||
Clearing Indicator Problems
ClassificationState
When the cooling fan
Action 1 system is not in normal operating condition.
When the lamp cover
Action 2 protecting the lamp unit is not properly closed or the sensor system is not in
Measures
If the symptom remains even after disconnecting and then reconnecting the power cord and turning the projector on again, contact your product provider or our service center.
Check whether the screws at the bottom side of the projector are fastened correctly. If they are abnormally fastened, contact your product distributor or service center.