Philips FW-D1 manual Maintenance, Troubleshooting, DVD-Video Player Operation

MAINTENANCE

•Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives.

Cleaning Discs

•When a disc becomes

dirty, clean it with a cleaning cloth. Wipe the disc from the

centre out.

•Do not use solvents such as benzine,

thinner, commercially available cleaners, or antistatic spray intended for analogue records.

Cleaning the disc lens

•After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good playback quality, clean the disc lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner.

40

TROUBLESHOOTING

Warning! Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock.

•If a fault occurs, check the points listed below before taking the system for repair.

•Should any problems persist after you have made these checks, consult your nearest dealer or service centre.

DVD-Video Player Operation

Distorted picture or no colour with player menu.

•The disc format does not match your

TV's video signal (PAL/NTSC).

™Replace a recommended disc (refer to the instruction of this manual).

•The system setting is not correct.

™Make sure the NTSC/PAL setting at the player matches the video signal of your

television (see NTSC/PAL setting).

•Check the disc for fingerprints.

™Clean with a soft cloth, wiping from centre to edge.

™Sometimes a small amount of picture distortion may appear, this is not malfunction.

No return to start-up screen when disc is removed.

•Check to see if the programme requires another disc to be loaded.

™Reload a disc.

™Reset by switching the player off, then on again.

Player does not respond to all operating commands during playback.

•Operations are not permitted by the disc.

™Refer to the instruction of the disc.

No audio at digital output.

•The digital connections are not properly connected or connected wrongly

™Check the digital connections.

• Incorrect digital output settings.

™Check the settings menu to make sure the digital output is set to ALL or PCM.

™Check if the audio format of the selected audio language matches the receiver capabilities.

No picture on TV screen.

•The video cable is not connected.

™Connect the cable between the system and TV.