Philips P7040P, Link manual Alert message, Troubleshooting checklist, Safety information

Models: Link P7040P

1 92
Download 92 pages 28.38 Kb
Page 40
Image 40

Alert message

If you experience any problem while using your mobile phone, please refer to the following checklist. If the problem still persists, contact your dealer or nearest carrier.

When the “Insert SIM Card” message appears:

Make sure the SIM card is correctly installed. Check to see if the SIM card is working properly. If it does not work, try to clean the contact points of the card with a dry cloth. If it is out of order, take it to your service provider.

When the “Messages full” message appears:

The received or saved messages are full in your phone memory. You need to delete the message.

When the “Phone and SIM messages are full. Delete Messages” message appears:

The received or saved messages are full in your phone and SIM card memory. You need to delete the message.

When the “Password” message appears in Phone locked state:

Enter the phone password. The default password is”1234”. If you cannot remember the password, contact the nearest carrier.

When the “Enter PIN1” message appears:

Input PIN1. If you cannot remember it, contact your service provider. You

74

can still receive calls even if your mobile phone becomes locked after entering the incorrect PIN1 on three consecutive attempts.

When the “No Service” or “Network Search” appears:

If you cannot make/receive a call when you are indoors or undergrounds where the signal strength is poor, move toward a window or go out to an open area. If you still cannot make a connection, contact your service provider.

Troubleshooting checklist

When audio quality is poor:

End a call and try again.

When the other party cannot hear you speaking:

Your phone may be set to MUTE. Disable the MUTE function. Or your hand may be covering the microphone located below the *.

When battery lifetime is shorter than usual:

This may happen when you are in an area with low signal strength. Turn off your phone when it is not in use. Change the battery when battery energy is exhausted.

When your mobile phone does not turn on:

Make sure your battery is charged. Check to see if your phone works while recharging the battery.

When you are unable to send a message:

Either you are not registered to receive an SMS service, or you may be in an area where your network service provider cannot provide such a service.

When you are unable to make a call:

Your phone may be set to“fixed dial.”Cancel the“fixed dial”function.

When you are unable to charge the battery:

This may be the result of one of the following three cases.

1.Your charger may be out of order. Contact your nearest dealer.

2.You may be attempting to use the phone in an overly hot/cold temperature. Try changing the charging environment.

3.Your battery may have not been connected to the charger properly. Check the connector.

When you are unable to input data into your Address Book:

Your Address Book memory may be full. Try deleting some entries from your Address Book.

When you are unable to select a certain function:

You may not have subscribed to that function, or your network service provider may be in an area where such service cannot be provided. Contact your local service provider.

Safety information

The following list shows how to maintain your mobile phone, together

01

with precautions to take.

02

– Keep your mobile phone and its accessories out of the reach of children

and pets.

03

– Maintain your mobile phone in dry conditions and keep it within normal

 

operating temperatures. Temperatures higher than 55°C (131°F) or

04

lower than -20°C (-4°F) may damage your phone.

05

– Do not try to dry your phone in a microwave oven. If not, sparks can

occur and cause an explosion or fire.

06

– Do not use or store your mobile phone in dusty, dirty areas.

07

– Do not attempt to disassemble your mobile phone.

– Do not drop or cause severe impact to your mobile phone.

08

– Do not use chemical products, cleaning solvents or detergents to clean

 

your mobile phone.

– If your mobile phone does not work properly, contact your dealer immediately.

– Use only authorized batteries, battery chargers and accessories. Any malfunction or damage caused by the use of unauthorized batteries, battery chargers and accessories will void the limited product warranty.

– Ensure that the battery and battery charger do not come in contact with conductive objects.

75

Page 40
Image 40
Philips P7040P, Link manual Alert message, Troubleshooting checklist, Safety information