Samsung ML-1200 manual Labels, Transparencies, Envelopes with

Paper Specifications

Envelopes with Double Side Seams

Double side-seam construction has vertical seams at both ends of the envelope rather than diagonal seams. This style may be more likely to wrinkle. Insure the seam extends all the way to the corner of the envelope as illustrated below.

Paper Specifications

Labels

CAUTIONS:

Correct

Incorrect

Envelopes with	Envelopes with a peel-off adhesive strip or with more than one
Adhesive Strips or Flaps	flap that folds over must use adhesive compatible with the heat
	and pressure in the printer. The extra flaps and strips may cause
	wrinkling, creasing, or even jams and may even damage the
	fuser.

•To avoid damaging the printer, use only labels recommended for laser printers.

•To prevent jams, always use the face-up output slot.

•Never print on the same sheet of labels more than once or print on a partial sheet of labels.

When selecting labels, consider the quality of each component:

•Adhesive: The adhesive material should be stable at 200 °C (392 °F), the printer’s fusing temperature.

•Arrangement: Only use labels with no exposed backing between them. Labels can peel off sheets with spaces between the labels, causing jams.

•Curl: Prior to printing, labels must lie flat with no more than 13 mm (.5 in.) of curl in any direction.

•Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.

Envelope Margins

Envelope Storage

The following gives typical address margins for a commercial #10 or DL envelope.

Type of Address	Minimum	Maximum
Return address	15 mm (0.6 in.)	15 mm (0.6 in.)
Delivery address	51 mm (2 in.)	89 mm (3.5 in.)

Notes:

•For best print quality, position margins no closer than 15 mm (0.6 in.) from the edges of the envelope.

•Avoid printing over the area where the envelope’s seams meet.

Proper storage of envelopes helps contribute to print quality. Envelopes should be stored flat. If air is trapped in an envelope, creating an air bubble, then the envelope may wrinkle during printing. See “Printing on Envelopes” on page 4.7.

See “Printing on Labels” on page 4.10.

Transparencies

Transparencies used in the printer must be able to withstand 200 °C (392 °F), the printer’s fusing temperature.

CAUTION: To avoid damaging the printer, use only transparencies recommended for use in laser printers.

See “Printing on Transparencies” on page 4.11.

A.8 APPENDIX APPENDIX A.9