SRP-370/372 Ver.2
1-2 Connecting the Cables
You can connect up the three cables to the printer. They all connect to the connector panel on the back of the printer, which is shown below:
※NOTE
Before connecting any of the cables, make sure that both the printer and the host are turned off.
POWERDK
Power supply | Drawer |
connector | connector |
Interface connector
※When the Dip Switch is “ON” on the Serial Interface Board, DTR and RTS are connected each other.
PRINTER |
|
|
|
|
| HOST | PRINTER |
|
|
|
|
| HOST |
SIDE (25P) |
|
|
| SIDE (25P) | SIDE (25P) |
|
|
|
| SIDE (9P) | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Pin No. | Signal name | Direction | Function |
1 | FG | - | Frame Ground |
2 | TxD | Output | Transmit Data |
3 | RxD | Input | Receive Data |
4 | RTS | Output | Ready To Send |
5 | CTS | Input | Clear To Send |
6 | DSR | Input | Data Set Ready |
7 | SG | - | Signal Ground |
20 | DTR | Output | Data Terminal Ready |
Rev. 2.01 | - 8 - |