SRP-370/372 Ver.2
1-5 Setting the Memory Switches
This printer has “Memory Switch” set which is software switches. Memory Switch set has “MSW1”, “MSW2”, “MSW8”, “MSW9” “Customize value”, “Serial communication condition”. “Memory Switch setting utility” can change the Memory Switch set to ON or OFF as shown in the table below (default : all OFF) :
※NOTE
The Memory Switch is available to be changed by three methods :
-Memory Switch setting utility.
-Control from ESC/POS command.
Settings of the Memory Switch are stored in the NV memory : therefore, even if the printer is turned off, the settings are maintained.
MSW1
Switch | Function | ON | OFF |
1~3 | Reserved | Fixed to OFF | |
4 | Cutting + Internal Bell | Enable | Disable |
| (Kitchen Printer) |
|
|
5 | Auto Line Feed | Enable | Disable |
6~8 | Reserved | Fixed to OFF | |
MSW2 |
|
|
|
Switch | Function | ON | OFF |
1 | Font Selection | Font B (9 x 24) | Font A (12 x 24) |
2 | Auto Cutter Function | Full Cutting | Partial Cutting |
3~8 | Code Page Selection | Refer to following Table |
|
Rev. 2.01 | - 13 - |