QUICK PROGRAMMING GUIDE
Access main menu (preset 95). See the Accessing Main Menu (Preset 95) section.
Use the joystick to position the cursor beside menu selection.
NOTE: If your controller does not have a joystick, use the up or down key.
Press Iris Open, the submenu/cursor moves to the right.
Move the joystick up or down to view selections.
Press Iris Open to make selection.
Press Iris Close to cancel selection.
ACCESSING MAIN MENU (PRESET 95)
You can call up the main menu on your monitor by programming (setting or creating) preset 95 (preset 28 if in
Programming preset 95 for Pelco’s controllers varies according to the type of controller you are using. Instructions for programming preset 95 are given below for various Pelco controllers.
CM6700/CM6800
1.Enter the number of the Spectra IV/Spectra IV SE dome system and press the CAM key.
2.Enter 95 and hold the PRESET key for two seconds.
3.In the Edit Preset menu, arrow to SET and press the ACK key. The main menu appears.
KBD200A/KBD300A (Direct Mode Only)
1.Enter 95.
2.Hold the PRESET key (approximately five seconds) until the main menu appears on the screen.
C3412M (9/06) | 21 |
