Pelco IV SE manual Installation, Switch Settings, SW1 - RECEIVER ADDRESS, AD-32Preset System

Installation

NOTE: This manual contains installation instructions only for the Spectra IV/Spectra IV SE dome drive. For complete installation instructions for a Spectra IV/Spectra IV SE dome system, refer to the installation manual shipped with the back box.

SWITCH SETTINGS

Before installing the dome drive, configure the receiver address, termination, and baud setting. The DIP switches used to configure these settings are located on the base of the dome drive.

Figure 1 shows the default settings for the DIP switches. Switch SW1-1 (SW1, switch 1) is set to the ON position. All other switches are set to the OFF position.

Refer to the following sections to set the address, termination, and baud settings for the dome drive.

O N
SW2
1	2	3	4	5	6	7	8	9	10

SW1

O N
1	2	3	4	5	6	7	8

Figure 1. Default Switch Settings

SW1 – RECEIVER ADDRESS

Set the SW1 switches for the address of the dome drive. The following information is required to set the dome drive address:

P-Type Control	Default address is 2. Refer to Table A for address settings that use P-type control. Maximum number
	of receivers is 32.
D-Type Control	Default address is 1. Refer to Table B for address settings that use D-type control. Maximum number
	of receivers is 254.

SW2 SWITCHES 1-3 – SPECIAL SYSTEM SETTINGS

AD-32 Preset System

SW2-1 should be set to the ON position if an AD-32 controller and Pelco’s TXB-AD translator board are used to control the dome system.

C3412M (9/06) 7